Enterasys Networks C2RPS-SYS manual Installation, Required Tools

Page 23

2

Installation

Electrical Hazard: Only qualified personnel should perform installation procedures.

Advertencia eléctrica: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.

This chapter provides the installation instructions to install all the components of an RPS.

To correctly install an RPS, follow the order of information listed below.

For information about...

Refer to page...

 

 

Required Tools

2-1

 

 

Unpacking Chassis and Power Supply Module(s)

2-1

 

 

Installing C2RPS-PSMs

2-2

 

 

Installing C2RPS-CHAS8 into the Rack

2-4

 

 

Connecting the PSM Cables and AC Power Cords

2-6

 

 

Required Tools

A flat‐blade screwdriver is required to install the C2RPS‐CHAS8 and C2RPS‐PSMs.

Unpacking Chassis and Power Supply Module(s)

The C2RPS‐CHAS8 and C2RPS‐PSM are shipped separately. To unpack these devices proceed as follows:

1.Open the box and remove the packing material protecting the devices.

2.Verify the contents of each carton and compare the contents shipped with those listed in Table 2‐1 and Table 2‐2.

SecureStack C2 Installation Guide 2-1

Image 23
Contents SecureStack C2 Redundant Power System Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Figures Structure of This Guide Using This GuideAbout this Guide Using the SecureStack C2 Manual Set Following conventions are used in this guide Conventions Used in This GuideConventions Used in This Guide Xiv About this Guide RPS Overview IntroductionC2RPS-CHAS8 Chassis Power supply slot cover Captive screw 2 per coverC2RPS-PSM front view C2RPS-PSM Power Supply ModuleRPS Deployment Strategies RPS Supporting a Group of Switches up to eightSupport@enterasys.com Getting HelpGetting Help Introduction Required Tools InstallationUnpacking Chassis and Power Supply Modules Installing C2RPS-PSMs C2RPS-PSM Installation Replacing an Installed C2RPS-PSMGuidelines for Rackmount Installation Installing C2RPS-CHAS8 into the RackRack Mounting the Chassis Fastening the C2RPS-CHAS8 to the Rack Connecting the PSM Cables and AC Power CordsC2RPS-PSM Cable C2RPS-PSM Cable and AC Power Cord Connections C2RPS-CHAS8 Chassis Specifications SpecificationsC2RPS-PSM Redundant Power Supply Output Connector C2RPS-PSM SpecificationsTable A-4 Compliance Standards Compliance StandardsCompliance Standards Specifications