Enterasys Networks C2RPS-SYS manual C2RPS-PSM Cable

Page 29

Connecting the PSM Cables and AC Power Cords

5.On certain switches, an LED indicator will show that a redundant power supply is now in operation.

.

Note: No change in switch configuration is necessary for this installation.

Figure 2-3 C2RPS-PSM Cable

Figure 2-4 Power Connectors on C2RPS-PSM (rear view)

Redundant Power Supply	AC LINE
	100-240 VAC
	50-60 Hz
	2A MAX

À	Á
1 Redundant Power Supply connector	2 AC power connector (rear of chassis)

SecureStack C2 Installation Guide 2-7

Image 29

Contents SecureStack C2 Redundant Power System Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Figures Structure of This Guide Using This GuideAbout this Guide Using the SecureStack C2 Manual Set Following conventions are used in this guide Conventions Used in This GuideConventions Used in This Guide Xiv About this Guide RPS Overview IntroductionC2RPS-CHAS8 Chassis Power supply slot cover Captive screw 2 per coverC2RPS-PSM front view C2RPS-PSM Power Supply ModuleRPS Deployment Strategies RPS Supporting a Group of Switches up to eightSupport@enterasys.com Getting HelpGetting Help Introduction Required Tools InstallationUnpacking Chassis and Power Supply Modules Installing C2RPS-PSMs C2RPS-PSM Installation Replacing an Installed C2RPS-PSMGuidelines for Rackmount Installation Installing C2RPS-CHAS8 into the RackRack Mounting the Chassis Fastening the C2RPS-CHAS8 to the Rack Connecting the PSM Cables and AC Power CordsC2RPS-PSM Cable C2RPS-PSM Cable and AC Power Cord Connections C2RPS-CHAS8 Chassis Specifications SpecificationsC2RPS-PSM Redundant Power Supply Output Connector C2RPS-PSM SpecificationsTable A-4 Compliance Standards Compliance StandardsCompliance Standards Specifications