Enterasys Networks C2RPS-SYS manual C2RPS-PSM Cable and AC Power Cord Connections

Page 30

Connecting the PSM Cables and AC Power Cords

Figure 2-5 C2RPS-PSM Cable and AC Power Cord Connections

Redundant Power Supply

AC LINE

100-240 VAC

STACK UPSTACK DOWN50-60 Hz 0.8 A MAX

MAC ADDRESS SERIAL NO.

À

RedundantPowerSupply	Á

Â

Å

Ä

AC LINE 100-240 VAC 50-60 Hz 2A MAX

Ã

1	Switch device	4	Switch device Redundant Power Supply connector
2	PSM cable	5	AC power cord (type varies depending on country)
3	PSM Redundant Power Supply	6	AC power outlet with ground connection (type
	connector		varies depending on country)

2-8 Installation

Image 30

Contents SecureStack C2 Redundant Power System Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Figures Using This Guide About this GuideStructure of This Guide Using the SecureStack C2 Manual Set Conventions Used in This Guide Following conventions are used in this guideConventions Used in This Guide Xiv About this Guide Introduction RPS OverviewPower supply slot cover Captive screw 2 per cover C2RPS-CHAS8 ChassisC2RPS-PSM Power Supply Module C2RPS-PSM front viewRPS Supporting a Group of Switches up to eight RPS Deployment StrategiesGetting Help Support@enterasys.comGetting Help Introduction Installation Unpacking Chassis and Power Supply ModulesRequired Tools Installing C2RPS-PSMs Replacing an Installed C2RPS-PSM C2RPS-PSM InstallationInstalling C2RPS-CHAS8 into the Rack Guidelines for Rackmount InstallationRack Mounting the Chassis Connecting the PSM Cables and AC Power Cords Fastening the C2RPS-CHAS8 to the RackC2RPS-PSM Cable C2RPS-PSM Cable and AC Power Cord Connections Specifications C2RPS-CHAS8 Chassis SpecificationsC2RPS-PSM Specifications C2RPS-PSM Redundant Power Supply Output ConnectorCompliance Standards Table A-4 Compliance StandardsCompliance Standards Specifications