Enterasys Networks C2RPS-SYS manual

Page 3

Electrical Hazard: Only qualified personnel should perform installation procedures.

Advertencia eléctrica: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.

Notice

Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made.

The hardware, firmware, or software described in this document is subject to change without notice.

IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN THEM, EVEN IF ENTERASYS NETWORKS HAS BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE POSSIBILITY OF SUCH DAMAGES.

Enterasys Networks, Inc.

50 Minuteman Road

Andover, MA 01810

2005 Enterasys Networks, Inc. All rights reserved. Part Number: 9033977‐01 April 2005

ENTERASYS, ENTERASYS NETWORKS, ENTERASYS MATRIX, LANVIEW, MATRIX, NETSIGHT, WEBVIEW, and any logos associated therewith, are trademarks or registered trademarks of Enterasys Networks, Inc., in the United States and other countries.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

Documentation URL: http://www.enterasys.com/support/manuals

Documentacion URL: http://www.enterasys.com/support/manuals

Dokumentation http://www.enterasys.com/support/manuals

i

Image 3
Contents SecureStack C2 Redundant Power System Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Figures Using This Guide About this GuideStructure of This Guide Using the SecureStack C2 Manual Set Following conventions are used in this guide Conventions Used in This GuideConventions Used in This Guide Xiv About this Guide RPS Overview IntroductionC2RPS-CHAS8 Chassis Power supply slot cover Captive screw 2 per coverC2RPS-PSM front view C2RPS-PSM Power Supply ModuleRPS Deployment Strategies RPS Supporting a Group of Switches up to eightSupport@enterasys.com Getting HelpGetting Help Introduction Installation Unpacking Chassis and Power Supply ModulesRequired Tools Installing C2RPS-PSMs C2RPS-PSM Installation Replacing an Installed C2RPS-PSMGuidelines for Rackmount Installation Installing C2RPS-CHAS8 into the RackRack Mounting the Chassis Fastening the C2RPS-CHAS8 to the Rack Connecting the PSM Cables and AC Power CordsC2RPS-PSM Cable C2RPS-PSM Cable and AC Power Cord Connections C2RPS-CHAS8 Chassis Specifications SpecificationsC2RPS-PSM Redundant Power Supply Output Connector C2RPS-PSM SpecificationsTable A-4 Compliance Standards Compliance StandardsCompliance Standards Specifications