Enterasys Networks C2RPS-SYS manual C2RPS-CHAS8 Chassis

Page 18

RPS Overview

C2RPS-CHAS8 Chassis

The chassis is a an eight‐slot frame without AC power connections or electronics. The chassis can be installed in a standard 19‐inch rack and populated with up to eight PSMs. Each PSM operates independently.

Figure 1‐1 shows the front view of the chassis with covers only; Figure 1‐2 shows the rear view if the chassis was fully populated with PSMs.

Figure 1-1 SecureStack C2RPS-CHAS8 (front view without PSMs)

 

C2RPS-CHAS8

À

Á

1 Power supply slot cover (8)

2 Captive screw (2 per cover)

Figure 1-2 SecureStack C2RPS-CHAS8 (rear view with eight PSMs)

Redundant Power Supply

Redundant Power Supply

Redundant Power Supply

Redundant Power Supply

Redundant Power Supply

Redundant Power Supply

Redundant Power Supply

Redundant Power Supply

AC LINE 100-240 VAC 50-60 Hz 2A MAX

AC LINE 100-240 VAC 50-60 Hz 2A MAX

AC LINE 100-240 VAC 50-60 Hz 2A MAX

AC LINE 100-240 VAC 50-60 Hz 2A MAX

AC LINE 100-240 VAC 50-60 Hz 2A MAX

AC LINE 100-240 VAC 50-60 Hz 2A MAX

AC LINE 100-240 VAC 50-60 Hz 2A MAX

AC LINE 100-240 VAC 50-60 Hz 2A MAX

_______________________________________________________________________________

1-2 Introduction

Image 18
Contents SecureStack C2 Redundant Power System Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Figures Using This Guide About this GuideStructure of This Guide Using the SecureStack C2 Manual Set Conventions Used in This Guide Following conventions are used in this guideConventions Used in This Guide Xiv About this Guide Introduction RPS OverviewPower supply slot cover Captive screw 2 per cover C2RPS-CHAS8 ChassisC2RPS-PSM Power Supply Module C2RPS-PSM front viewRPS Supporting a Group of Switches up to eight RPS Deployment StrategiesGetting Help Support@enterasys.comGetting Help Introduction Installation Unpacking Chassis and Power Supply ModulesRequired Tools Installing C2RPS-PSMs Replacing an Installed C2RPS-PSM C2RPS-PSM InstallationInstalling C2RPS-CHAS8 into the Rack Guidelines for Rackmount InstallationRack Mounting the Chassis Connecting the PSM Cables and AC Power Cords Fastening the C2RPS-CHAS8 to the RackC2RPS-PSM Cable C2RPS-PSM Cable and AC Power Cord Connections Specifications C2RPS-CHAS8 Chassis SpecificationsC2RPS-PSM Specifications C2RPS-PSM Redundant Power Supply Output ConnectorCompliance Standards Table A-4 Compliance StandardsCompliance Standards Specifications