Enterasys Networks XSR-3150 manual Enterasys Networks, Inc. Firmware License Agreement

Page 10

Enterasys Networks, Inc. Firmware License Agreement

BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT,

CAREFULLY READ THIS LICENSE AGREEMENT.

This document is an agreement (“Agreement”) between the end user (“You”) and Enterasys Networks, Inc., on behalf of itself and its Affiliates (as hereinafter defined) (“Enterasys”) that sets forth Your rights and obligations with respect to the Enterasys software program/firmware (including any accompanying documentation, hardware or media) (“Program”) in the package and prevails over any additional, conflicting or inconsistent terms and conditions appearing on any purchase order or other document submitted by You. “Affiliate” means any person, partnership, corporation, limited liability company, other form of enterprise that directly or indirectly through one or more intermediaries, controls, or is controlled by, or is under common control with the party specified. This Agreement constitutes the entire understanding between the parties, with respect to the subject matter of this Agreement. The Program may be contained in firmware, chips or other media.

BY INSTALLING OR OTHERWISE USING THE PROGRAM, YOU REPRESENT THAT YOU ARE AUTHORIZED TO ACCEPT THESE TERMS ON BEHALF OF THE END USER (IF THE END USER IS AN ENTITY ON WHOSE BEHALF YOU ARE AUTHORIZED TO ACT, “YOU” AND “YOUR” SHALL BE DEEMED TO REFER TO SUCH ENTITY) AND THAT YOU AGREE THAT YOU ARE BOUND BY THE TERMS OF THIS AGREEMENT, WHICH INCLUDES, AMONG OTHER PROVISIONS, THE LICENSE, THE DISCLAIMER OF WARRANTY AND THE LIMITATION OF LIABILITY. IF YOU DO NOT AGREE TO THE TERMS OF THIS AGREEMENT OR ARE NOT AUTHORIZED TO ENTER INTO THIS AGREEMENT, ENTERASYS IS UNWILLING TO LICENSE THE PROGRAM TO YOU AND YOU AGREE TO RETURN THE UNOPENED PRODUCT TO ENTERASYS OR YOUR DEALER, IF ANY, WITHIN TEN (10) DAYS FOLLOWING THE DATE OF RECEIPT FOR A FULL REFUND.

IF YOU HAVE ANY QUESTIONS ABOUT THIS AGREEMENT, CONTACT ENTERASYS NETWORKS, LEGAL DEPARTMENT AT (978) 684‐1000.

You and Enterasys agree as follows:

1.LICENSE. You have the non‐exclusive and non‐transferable right to use only the one (1) copy of the Program provided in this package subject to the terms and conditions of this Agreement.

2.RESTRICTIONS. Except as otherwise authorized in writing by Enterasys, You may not, nor may You permit any third party to:

(a)Reverse engineer, decompile, disassemble or modify the Program, in whole or in part, including for reasons of error correction or interoperability, except to the extent expressly permitted by applicable law and to the extent the parties shall not be permitted by that applicable law, such rights are expressly excluded. Information necessary to achieve interoperability or correct errors is available from Enterasys upon request and upon payment of Enterasys’ applicable fee.

(b)Incorporate the Program in whole or in part, in any other product or create derivative works based on the Program, in whole or in part.

(c)Publish, disclose, copy reproduce or transmit the Program, in whole or in part.

(d)Assign, sell, license, sublicense, rent, lease, encumber by way of security interest, pledge or otherwise transfer the Program, in whole or in part.

(e)Remove any copyright, trademark, proprietary rights, disclaimer or warning notice included on or embedded in any part of the Program.

3.APPLICABLE LAW. This Agreement shall be interpreted and governed under the laws and in the state and federal courts of the Commonwealth of Massachusetts without regard to its conflicts of laws provisions. You accept the personal jurisdiction and venue of the Commonwealth of Massachusetts courts. None of the 1980 United Nations Convention on the Limitation Period in the International Sale of Goods, and the Uniform Computer Information Transactions Act shall apply to this Agreement.

4.EXPORT RESTRICTIONS. You understand that Enterasys and its Affiliates are subject to regulation by agencies of the U.S. Government, including the U.S. Department of Commerce, which prohibit export or diversion of certain technical products to certain countries, unless a license to export the product is obtained from the U.S. Government or an exception from obtaining such license may be relied upon by the exporting party.

If the Program is exported from the United States pursuant to the License Exception CIV under the U.S. Export Administration Regulations, You agree that You are a civil end user of the Program and agree that You will use the Program for civil end uses only and not for military purposes.

viii

Image 10
Contents PeditionSecurity Router VersionPage Enterasys Networks, Inc Minuteman Road Andover, MA Regulatory Compliance Information Industry Canada Notices Product Safety Supplement to Product Instructions Vcci Notice N826 Enterasys Networks, Inc. Firmware License Agreement Page Page Contents BRI Leased Line BRI Leased Frame Relay BRI Switched Line Appendix a Specifications IndexXiv Contents of the Guide About This GuideBold/En negrilla Getting Help FTPXviii Overview System DescriptionHardware Features Typical XSR-3150 TopologyXSR-3150 Industry-common CLI Software FeaturesOperating System IP ProtocolIP Routing Snmp and Statistics GatheringSecurity Frame RelayDynamic Host Configuration Protocol Dhcp Integrated Services Digital Network Isdn BRI/PRIQuality of Service QoS Virtual Private Network VPNGRE over IPSec Asynchronous Digital Subscriber Line Adsl Dial ServiceDial Backup Dial-on-Demand/Bandwidth-on-Demand DoD/BoDInstallation Overview Unpack the XSR from the shipping box. Remove accessoriesInstallation Overview Introduction Installation Site SuggestionsVerifying Your Shipment Installing NIM Cards and Rack Mounting Removing XSR CoverXSR Fastening Rack Brackets Installing a CompactFlash Memory Card CompactFlash Card InstallationCompactFlash Card for the Adsl NIM Formatting the CompactFlash CardConnecting Cables 315011 Connecting High Speed Serial Connector 13 Connecting Adsl Connector 15 Attaching GigabitEthernet Connector 17 Attaching Ethernet LAN NIM Connector 19 Connecting Dual Internal Power Supply Cords Software Configuration Initializing XSR SoftwareInitializing XSR Software Configuring RAI for Frame Relay Optional Configuring Remote Auto InstallOpening a COM Console Session Remote Auto Install Attempting Forever Configuring RAI for Dhcp over LAN Configuring RAI over AdslPppoe limit max-sessions Setting the Clock Configuring the XSR Name and User InformationSetting User Name, Privilege and Password Configuring the WAN Ports Configuring the LAN PortsPRI Configuration BRI Configuration BRI Leased LineBRI Switched Line BRI Leased Frame RelayPPPoE Adsl ConfigurationPPPoA Firewall Sample Configuration IPoAXSR Setting Up RIP Routing Complete LAN and WAN interface configurationConfigure Ospf Routing Configuring Frame Relay Point to Point NetworksSetting Up an Snmp Community String, Traps and V3 Values Configuring Message Logging and Severity Level Viewing Your Configuration Connecting Remotely via the WebWeb Product Version Window LAN-PPP Services Sample Configuration PstnXSRconfig-controllerT1-1/0#no shutdown Configure LAN Interface Frame Relay WAN Link with PPP Backup Sample ConfigurationConfigure Users and Passwords Configure Quality of ServiceConfigure WAN/Frame Relay Port XSRconfig-pmap-cpriority-policy#priority high 30XSRconfig#interface serial 1/0.2 multipoint Apply QoSConfigure DHCP/BOOTP Relay Configure Ospf RoutingConfigure More Access Lists Configure the Dial Backup ConnectionConfigure Snmp Configure Access Control Lists VPN Site-to-Site Sample ConfigurationGenerate Master Encryption Key Configure Crypto Maps Set Up IKE Phase I SecurityConfigure IKE Policy for Remote Peer Create a Transform SetConfiguring VPN at Interface Mode and Setting Up RIP VPN Sample Configuration with Network Extension Mode Configuring Authentication AAAEnable Network Address Translation Create the Isakmp IKE global peer XSR Rebooting Characteristics Initialization OutputReboot Triggers Power-Up RebootBootrom Monitor Mode Commands Power-up Error ConditionsXSR-3150 bu btXSR300012.fls Verifying btXSR300012.fls file Copy Del DirFfc Remove RenameFTP Bootrom Monitor Mode Commands Specifications System SpecificationsCable, CompactFlash and Accessory Specifications WANXSR Getting Started Guide A-3 COM Console Port COMGigabitEthernet Ports Mini-GBIC Fiber, Copper PortRegulatory/Safety Compliance Copper/Fiber-optic Ethernet NIMsPort Serial NIM Card Port 21 DTEFigure A-8 EIA-232/530 DTE Pin Assignments Figure A-9 EIA-449 DTE Pin Assignments Figure A-10 Combined V.35/EIA-232/530 DTE Pin Assignments Figure A-11 DTE Pin Assignments T1/E1/ISDN PRI NIM Card Ports T1/E1/ISDN PRIBalun for E1 or PRI NIM Cards Figure A-14 Balun for E1 or PRI ConnectionInstalling Shunt/Terminal Strip Grounding Shunt for E1 NIM CardsT3/E3 NIM Card Figure A-17 1-Port T3/E3 NIM CardPort BRI-S/T Isdb NIM Card Ports Termination Shunt for the Isdn BRI-S/T NIM CardXSR Getting Started Guide A-17 Port BRI-U NIM Card Ports Figure A-21 Isdn BRI-U NIM Card RJ-49C ports shownPort Adsl NIM Card Port Figure A-23 Adsl NIM CardT1/E1 Drop & Insert D&I NIM Figure A-25 T1/E1 D&I NIM CardCompactFlash Memory Card LED BehaviorTX LED Index Index-2