Memory Locations and Replacement Procedures
module names, are reset to the factory default settings. Once the module resets, you can either use the factory default settings or reenter your own parameters.
•Switch 8 – Clear Admin Password. Changing the position of this switch clears the admin password, and restores the factory default password on the next power‐up of the module. Once the module resets, you can either use the factory default settings or reenter your own password.
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to its factory default setting.
Figure B-1 Mode Switch Location on the NAC Controller PEP (2S4082-25 shown)
1Mode switch bank
Memory Locations and Replacement Procedures
In the event that the Dual In‐Line Memory Module (DIMM) or DRAM Single In‐line Memory Module (SIMM) needs to be replaced, the following sections describe how to access, locate, and replace these memory modules. If you have questions concerning the replacement of either memory module, refer to “Getting Help” on page xviii for details on how to contact Enterasys Networks.
Location of Memory Modules
The location on the main board of the DRAM SIMM and DIMM for both the 2S4082‐25 and the 7S4280‐19 are the same. Figure B‐2 shows the locations of the DRAM SIMM and DIMM on the main board of the 2S4082‐25.