Enterasys Networks 7H4385-49 manual Led, Color State Recommended Action

Using LANVIEW

3.Press the GROUP SELECT button again for more than one second. This returns the 7H4385‐49 to the default status mode to monitor RX (receive) and TX (transmit) activity.

Table 4‐1 describes the LED indications and provides recommended actions as appropriate.

Note: The terms used in Table 4-1indicate the following:

• Flashing indicates LED is flashing randomly.

•Blinking indicates LED is flashing at a steady rate (approximately 50% on, 50% off).

•Solid indicates a steady LED light. No pulsing.

•Alternating indicates LED is flashing in a steady rate other than 50% on, 50% off.

Table 4-1 LANVIEW LEDs

LED	Color	State	Recommended Action
MGMT	Off	Off. This DFE module is NOT	None.
		the Management Module.
	Green	Solid. This module is the	None.
		designated Management
		Module.
	Amber	Flashing. This is a	None.
		temporary indication that the
		DFE module is saving data.
CPU	Off	Power off.	Ensure chassis has adequate power.
	Amber	Blinking. DFE module in	None.
		process of booting.
		Solid. Testing.	If the LED remains amber for several
			minutes, contact Enterasys Networks
			for technical support.
	Green	Blinking. Image starts	None.
		running.
		Solid. Functional.	None.
	Red	Solid. Processor in reset.	None.
	Green and Blinking. Indicates that the		None. This state is activated when the
	Amber	DFE module is in the process	OFFLINE/RESET switch is pressed for
		of shutting down.	less than 1 second to start the process
			of an orderly shutdown.

While in this state, do not remove any

DFE module.

DFE-Platinum Series Hardware Installation Guide 4-3