Enterasys Networks A2H254-16 manual Lanview LEDs, Color State Recommended Action

			Using LANVIEW
Table 4-1 LANVIEW LEDs
LED	Color	State	Recommended Action
CPU	Off	Power disconnected.	If the LED remains off after connecting AC
			power or DC power from an RPS, check
			the following:
			1. Make sure there is power at the power
			source (AC source and RPS if
			applicable).
			2. Replace the power cord with a known
			good one or check the continuity of the
			power cord.
			3. If the SecureStack A2 still does not
			power up, the system may have a fatal
			error. Contact Enterasys Networks for
			technical support.
	Red	Solid. Boot-up failed.	If the LED remains red for several
			minutes, the system may have a fatal
			error. Contact Enterasys Networks for
			technical support.
		Blinking. Diagnostics have	Contact Enterasys Networks for technical
		failed.	support.
	Amber	Solid. Diagnostics are running. If the LED remains amber for more than
			several minutes, contact
			Enterasys Networks for technical support.
		Blinking. Code image is being	None.
		downloaded, or the Manager
		switch is copying its
		configuration to the other
		members in the stack (this
		happens automatically every
		15 minutes and every time the
		“save config” command is
		executed.
	Green	Solid. System is fully	None.
		functional.
		Blinking. Boot-up in process.	None.

SecureStack A2 Installation Guide 4-3