|
|
| Completing the Installation |
| Modem Port Adapter Wiring and Signal Diagram | ||
RJ45 |
| DB25 |
|
Pin | Conductor | Pin | Signal |
1 | Blue | 2 | Transmit (TX) |
2 | Orange | 8 | Data Carrier Detect (DCD) |
4 | Red | 3 | Receive |
5 | Green | 7 | Ground (GRD) |
6 | Yellow | 20 | Data Terminal Ready (DTR) |
8 | Gray | 22 | Ring Indicator |
| Pins |
| Pins |
1 | 8 |
| |
1 | 13 | ||
RJ45 Connector (Female) | 14 | 25 | |
|
| DB25 Connector (Male) | |
Completing the Installation
Completion of the DFE module installation depends upon the type of system in which the module is being installed.
•If installing in a new DFE module system, refer to “Completing the Installation” on page 3‐29.
•If installing in an established, operating DFE module system, refer to “Completing the Installation of a DFE‐Gold Module in an Existing System” on page 3‐31.
Completing the Installation of a New System
In a new system of DFE modules, one of the installed DFE modules will become the management module on chassis power up, and all DFE modules will automatically be set to the factory default values. A complete list of the factory default values are provided in Chapter 3 of the Matrix DFE‐Gold Series Configuration Guide.
After installing all DFE‐Gold modules into the host chassis and making the connections to the network, proceed to the following First‐Time Log‐In Using a Console Port Connection procedure to access the module management startup screen from your PC, terminal, or modem connection.
Matrix