Wall Control Installation
1.Unpack the Wall Switch Remote Control and all hardware from its package.
2.Release the Controller from its Outer Housing by pushing the front face into the Outer Housing until you hear a click. This will release the push- lock latches and allow the Controller to be removed from the Outer Housing (Figure 5).
3.Push the wire lead storage compartment cover on the back of the Control towards the right (as shown), and remove (Figure 10).
Figure 10
4.Uncoil the two wire leads and feed each of them through one
of the two holes located on the wire lead storage compartment cover (make sure orientation is as shown as in Figure 11).
Figure 11
5.Replace the wire lead storage compartment cover on the Controller with wire leads fed through and exposed.
6.Feed the two wire leads from the Controller through the two holes in the back of the Outer Housing as shown in Figure 12.
7.Gently pull the wire leads through while pushing the Controller into the Outer Housing until you hear the push lock latches click, locking the Controller in place (Figure 13).
10 | www.dimplex.com |