Wall Control Installation
2.Release the Controller from its Outer Housing by pushing the front face into the Outer Housing until you hear a click. This will release the push- lock latches and allow the Controller to be removed from the Outer Housing (Figure 5).
Figure 5 | Outer |
| Housing |
3.Open the Battery Compartment as shown in Figure 6 and remove the Insulating Strip as shown in Figure 7.
Figure 7
Insulating
Strip
Controller
Figure 6
Battery
Compartment
4.Replace the battery compartment cover.
5.Reinsert the Controller back into the Outer Housing by realigning the tracks on the top and bottom of the unit with the guides inside the Outer Housing. Push the Controller in until you hear the push- lock latches click (Figure 8).
6.Slide the Controller and Outer Housing assembly into a standard device box and fasten with the two (2) flat
8 | www.dimplex.com |