Dimplex WRCPF-KIT owner manual Operation, DF3033ST and DFG3033 Models, Manual Controls

Page 15

Initialization

DF3033ST and DFG3033 Models

1.Ensure that power is supplied through main service panel.

2.Ensure the Main On/Off Switch located in the switch box on the fireplace in the upper right hand corner is in the On position (Figure 19A).

Figure 19

C B A

DF3033ST / DFG3033

Manual controls

3.Set the 3 Position Manual Control (Figure 19B) to the Remote position (left position).

4.Press and hold the Initialization Button on the unit (Figure 19C).

5.While holding the Initialization Button, press any button

on the Wall Switch Remote Control.

6.Release the Initialization Button and button pressed on the Control, sender is initialized with the fireplace.

Operation

Manual Controls

The following instructions will cover the operation of the manual controls installed with the receiver board contained with this kit (BF unit installations). For the operation of manual controls

for other installations (BLF50, DF3033ST and DFG3033), please consult your Owner's Manual for those specific models.

The fireplace can be controlled with switches located on the receiver as shown in Figure 20.

!NOTE: Firebox must have the Main On/Off and mode selector switch in the full on position for all features to work properly.

15

Image 15
Contents WRCPF-KIT Table of Contents Please carefully read and save these instructions Welcome & CongratulationsBF33STP BF33DXP BF39STP BF39DXP BF45DXP Product OverviewReceiver Installation BF units only Antenna Wall Control Installation Battery Powered InstallationRequired Tools and Hardware Outer Hard Wired Power Supplied Installation Wall Control Installation Locking Screw Option Figure Wire leads Wall Control Installation BF Models Using the Included Receiver Module InitializationBLF50 Models Operation DF3033ST and DFG3033 ModelsManual Controls Off Button Manual Selection SwitchLED Indicators On ButtonRoom Temperature Wall Switch Remote Control Display OperationSet Temperature Flame Effect IconPurifire Icon Hour Sleep Timer RF Code Function and Change ProcedureWarranty