Receiver Installation (BF units only)
1.Open steel curtain (remove glass doors if applicable).
2.Remove two (2) screws on log grate and remove log grate (Figure 1).
Figure 1
Screws
Manual Controls
3.Pull front edge of plastic ember bed grate up and forward until rear tab releases from the ledge located at the bottom of the partially reflective glass (Figure 2).
!NOTE: Log set fits tightly into firebox, some force may be necessary to remove.
Figure 2 |
| Log |
|
| |
Back |
| ember |
| bed | |
ledge |
| |
|
| |
Rear |
|
|
tab | Side section | Front |
| edge | |
|
|
4.Locate and remove the two (2) screws on the manual control bracket (Figure 3). Remove the bracket.
5.Locate and depress the mounting tabs on the plug connector and remove the manual control bracket from fireplace (Figure 3).
Figure 3 | Screw locations |
|
Mounting tabs
Manual controls | Plug | |
connector | ||
|
5