Antenna

6.Locate the plastic 9-pin plug in the bottom corner of the fireplace where the manual controls were plugged in to.

7.Insert the plug connector from the remote control bracket (Figure 4) into plastic plug inside the fireplace.

Figure 4

	Plug
Remote Control	Connector

8.Run black antenna wire under remote bracket and ensure all wiring is placed such that it does not interfere with re- assembly.

9.Install the two (2) screws removed in step 4 into the remote control bracket and attach it to the fireplace.

10.Replace the log set by inserting front edge and pushing the back down until rear tab snaps under back

ledge (Figure 2) and the logs are resting against the partially reflective glass.

11.Replace log grate using two

(2) screws previously removed in step 2.

6	www.dimplex.com