Digital Media 900TL Installing a MAU in a DEChub 900 MultiSwitch, Install the MAU in the hub

Page 5

Installing a MAU in a DEChub 900 MultiSwitch

When you install a MAU in a DEChub 900 MultiSwitch, you do not have to turn off the hub power.

Remove the single-slot hub (if necessary).

If you want to install a DEChub ONE MAU 900TL in a hub, you need to remove the single-slot hub.

a. Loosen the screw on the single-slot hub until it disengages.

b. With one hand holding the front of the MAU, and your other hand holding the single-slot hub, carefully pull the two units apart.

2Install the MAU in the hub.

The release lever is lifted and clicks back into place

as the module is seated.

a.Align the MAU's 48-pin connector with any available 48-pin slot on the hub.

b.Place the MAU's bottom mounting tab into the mounting slot on the hub.

c.Rock the MAU into place. You hear a ``clickº when the MAU is seated.

Mounting tab

LKG±8139-93I

DECmau 900TL

5

Image 5

Contents DEChub ONE MAU 900TL InstallationEK±DTMAU±IN. A01 CopyrightFront Panel Rear Panel of DEChub ONE MAU 900TL Remove the single-slot hub if necessary Installing a MAU in a DEChub 900 MultiSwitchInstall the MAU in the hub Connect station cables Verify powerSet Autowrap switches Installing a DEChub ONE MAU 900TLConnect power supply Mount MAU optionalCheck LEDs Install a MAU to adjacent MAUs or repeatersRemoving a MAU from a DEChub 900 MultiSwitch Off Flashing LED SummaryHub MAU only DEChub ONE onlyCabling DEChub 900 MultiSwitch ConfigurationDEChub ONE Configurations Shielded Twisted-Pair Cable Configuration Cable Connector SpecificationsMAU Connector Signal Names Total Cable Budget for UTP Level 5 Cable at 4 Mb/s1Then Do This DEChub 900 MultiSwitch and DEChub ONE Problem SolvingThen Do This DEChub 900 MultiSwitch only Associated Document Product SpecificationsProduct Specification A Hub DEChub ONE