Digital Media 900TL manual Removing a MAU from a DEChub 900 MultiSwitch

Page 9

Removing a MAU from a DEChub 900 MultiSwitch

Disconnect the station connector cables from the MAU.

2Remove the MAU from the hub.

Note:

When you remove a MAU from the hub, do not turn off the hub power.

The release lever is lifted and clicks back into place as the module is removed.

a.Lift up the Release lever on the hub.

b.Pivot the MAU back on its bottom mounting tab until it disengages from the hub.

Mounting tab

LKG±8144-93I

DECmau 900TL

Image 9

Contents DEChub ONE MAU 900TL InstallationEK±DTMAU±IN. A01 CopyrightFront Panel Rear Panel of DEChub ONE MAU 900TL Installing a MAU in a DEChub 900 MultiSwitch Install the MAU in the hubRemove the single-slot hub if necessary Connect station cables Verify powerSet Autowrap switches Installing a DEChub ONE MAU 900TLConnect power supply Mount MAU optionalCheck LEDs Install a MAU to adjacent MAUs or repeatersRemoving a MAU from a DEChub 900 MultiSwitch Off Flashing LED SummaryHub MAU only DEChub ONE onlyDEChub 900 MultiSwitch Configuration DEChub ONE ConfigurationsCabling Shielded Twisted-Pair Cable Configuration Cable Connector SpecificationsMAU Connector Signal Names Total Cable Budget for UTP Level 5 Cable at 4 Mb/s1Then Do This DEChub 900 MultiSwitch and DEChub ONE Problem SolvingThen Do This DEChub 900 MultiSwitch only Product Specifications Product Specification A Hub DEChub ONEAssociated Document