Digital Media 900TL manual Install a MAU to adjacent MAUs or repeaters, Check LEDs

Page 8

Connect station cables to any available lobe connector on the MAU. For

150-ohm applications, you also need an impedence matching transformer cable (Digital part number BN26T-03).

5Install a MAU to adjacent MAUs or repeaters.

If a MAU is being added to an existing

network, connect Ring In to the Ring Out connector of a MAU or repeater, and

connect Ring Out to the Ring In connector of a MAU or repeater.

With power on, verify that the Power and

Module OK LEDs are on.

Module installation for a DEChub ONE MAU 900TL is complete.

LKG±8143-93I

8	DECmau 900TL

Image 8

Contents Installation DEChub ONE MAU 900TLCopyright EK±DTMAU±IN. A01Front Panel Rear Panel of DEChub ONE MAU 900TL Remove the single-slot hub if necessary Installing a MAU in a DEChub 900 MultiSwitchInstall the MAU in the hub Verify power Connect station cablesInstalling a DEChub ONE MAU 900TL Set Autowrap switchesConnect power supply Mount MAU optionalInstall a MAU to adjacent MAUs or repeaters Check LEDsRemoving a MAU from a DEChub 900 MultiSwitch LED Summary Off FlashingHub MAU only DEChub ONE onlyCabling DEChub 900 MultiSwitch ConfigurationDEChub ONE Configurations Cable Connector Specifications Shielded Twisted-Pair Cable ConfigurationMAU Connector Signal Names Total Cable Budget for UTP Level 5 Cable at 4 Mb/s1Problem Solving Then Do This DEChub 900 MultiSwitch and DEChub ONEThen Do This DEChub 900 MultiSwitch only Associated Document Product SpecificationsProduct Specification A Hub DEChub ONE