Digital Media 900TL manual Verify power, Connect station cables

Page 6

Installing a MAU in a DEChub 900 MultiSwitch (continued)

3Verify power.

With power on in the hub, verify that the

Power and Module OK LEDs are on.

LKG±8141-93I

4 Connect station cables.

Connect station cables to any available lobe connector on the MAU. For 150-ohm applications, you also need an impedence matching transformer cable (Digital part number BN26T-03).

Module installation for a DEChub 900 MultiSwitch is complete.

PK±02570±IL

LKG±8140-93I

6	DECmau 900TL

Image 6

Contents Installation DEChub ONE MAU 900TLCopyright EK±DTMAU±IN. A01Front Panel Rear Panel of DEChub ONE MAU 900TL Installing a MAU in a DEChub 900 MultiSwitch Install the MAU in the hubRemove the single-slot hub if necessary Verify power Connect station cablesConnect power supply Installing a DEChub ONE MAU 900TLSet Autowrap switches Mount MAU optionalInstall a MAU to adjacent MAUs or repeaters Check LEDsRemoving a MAU from a DEChub 900 MultiSwitch Hub MAU only LED SummaryOff Flashing DEChub ONE onlyDEChub 900 MultiSwitch Configuration DEChub ONE ConfigurationsCabling MAU Connector Signal Names Cable Connector SpecificationsShielded Twisted-Pair Cable Configuration Total Cable Budget for UTP Level 5 Cable at 4 Mb/s1Problem Solving Then Do This DEChub 900 MultiSwitch and DEChub ONEThen Do This DEChub 900 MultiSwitch only Product Specifications Product Specification A Hub DEChub ONEAssociated Document