9
4.0Configuration
This section describes how to reconfigure options using the Configuration mode, including: input and output voltage and frequency, site wiring fault, and silencing the alarm.
NOTE The UPS has been
Configuration Mode
The control buttons ( 
and ↵ ) are used to modify the UPS configuration. Figure 7 shows the
front panel and Table 1 explains the corresponding options.
NOTE The UPS can be configured while in Battery mode. If the UPS switches to battery power while in Configuration mode, the UPS exits Configuration mode and indicates Battery mode on the front panel.
1.Press the 
button for one second to enter Configuration mode. The LCD displays the first configuration parameter (see Table 1).
2.Press the 
button to scroll through the parameters.
NOTE The UPS exits Configuration mode automatically after five seconds if a selection has not been made.
3.Press the ↵ button to select the parameter.
4.Press the 
button to scroll through the options for the selected parameter; press the ↵
button to select the option.
You may be prompted to save the selection; press the ↵ button to save. Other options are saved automatically. See Table 1 for more detail.
5.To exit Configuration mode at any time, do not press any buttons for five seconds. The UPS returns to Normal mode and displays On Line.
Press the Scroll button to enter Configuration mode. Also press to scroll to the next option.
Press the Enter button to select a parameter. Also press the Enter button to select an option and to save the setting.