Eaton Electrical 9120 manual Installing Lansafe Software, Relay Card AS/400 Pin Assignment

14

5.7Relay Card

This interface provides true relay contact output to peripheral devices. Outputs are user-selectable as normally open or normally closed.

Table 2. Relay Card (AS/400) Pin Assignment

Pin Number	Signal Name		Definition		Direction
1	-		Isolated common to pins 2 & 3		-
2	Line OK		Relay contact; closed to pin 1		-
3	Line Failure		Relay contact; closed to pin 1		-
4	-		Isolated common to pins 5 & 6		-
5	Battery Normal		Relay contact; closed to pin 4		-
6	Battery Low		Relay contact; closed to pin 4		-
7	-		Isolated common to pins 8 & 9		-
8	UPS Alarm		Relay contact; closed to pin 7		-
9	UPS On/OK		Relay contact; closed to pin 7		-
10	-		Isolated common to pins 11 & 12		-
11	UPS Online/Inverter		Relay contact; closed to pin 10		-
12	UPS on Bypass		Relay contact; closed to pin 10		-
13	+12VDC		Signal supply +12VDC		Out
14	Signal GND		Signal ground - Common		-
15	UPS Shutdown		Minimum 5 seconds high level		In
			signal (+12VDC) to perform
			shutdown according to following
			Relay Card Jumper settings:
		JP1 (default)	JP2		JP3
UPS Normal		-	No response	Go to bypass mode,
				back online when
				shutdown pins opened
UPS on Battery		Output off after	Immediate output off	Immediate output off
		120 sec. Back online	UPS shutdown in	UPS shutdown in
		on resumption of AC	12 seconds	12 seconds
		power

6.0Installing Lansafe Software

Your UPS is supplied with a CD-ROM and communication cable to install and operate Lansafe power man- agement software. To install Lansafe on your computer, follow the instructions enclosed with the Software Suite CD-ROM.