Eaton Electrical 9120 manual Configuration Mode Parameters

11

Table 1. Configuration Mode Parameters (cont.)

Parameter	LCD Message	Description	Default Settings
Manual Battery Test	Manual Bat Test	To initiate a manual battery test, press the ↵ button	Battery Test
		twice when “Manual Battery Test” is displayed on the
		LCD. During the test the LCD displays ON BATTERY.
		The UPS resets the automatic timer after a manual
		battery test. The LCD displays “Battery not charged”
		when UPS test is requested but the battery is not
		fully charged.
Manual UPS Test	Manual UPS Test	To initiate a manual UPS self-test, press the ↵ button	UPS Test
		twice. During the test, the LCD displays ON BATTERY.
Site Wiring Fault Alarm	Site Fault Set	Select Enable or Disable. When enabled, the alarm sounds	Detect Enable
		when the ground connection is missing or the line and
		neutral wires are reversed in the wall outlet.
Modem Support	Modem Support	This parameter is reserved for future use, and should not	No Modem Support
		be modified by the user.
Number of Extended	Bat Pack Num Set	Select the number of EBMs connected to the UPS:	Extern Pack: 0
Battery Modules		• For 700-1500 VAmodels, select 0 through 2
		• For 2000-3000 VAmodels, select 0 through 5.
		You are prompted to save this setting. Refer to the
		documentation that came with your battery pack for
		more information.
Communications Lock-	COM Control	For greater levels of security, users may choose to have	Enable
out	Cmds	the UPS disregard shutdown commands that come from
		the power management software or other communication
		sources.
		• When disabled, the UPS does not accept a shut down
		command via the communication port, USB port, or
		communication slot adapter.
		• When enabled, the UPS operates normally in response
		to external commands.
		You are prompted to save this setting.
Load Segment Control	Load Group Set	Allows manual control of load segments (see “Load	Group 1On 2On
		Segments” Section 5.3)
		By repeatedly pressing the scroll button, the individual
		load segments can be turned on and off.
		CAUTION To prevent the unintentional shutdown of
		specific load segments, confirm your selection before
		pressing the ↵ button.
Manual Bypass	Manual Bypass	This parameter is used to manually place the UPS in	Bypass OFF
	GO	Bypass mode.
Configuration Mode	Config Mode Set	This parameter is reserved for future use, and should not	EscapeConfigMode
Setting		be modified by the user. The setting may be toggled
		between EscapeConfigMode and Enter ConfigMode. 5.0
		It should always be set to EscapeConfigMode.