Lyngdorf Audio owner manual Rear Panel, TDA 2200 rear panel

Page 12
6. Rear Panel

6. Rear Panel

Fig 2: TDA 2200 rear panel.

DIGITAL INPUT 1-3 (1)

RCA Connectors for SPDIF input

DIGITAL OUTPUT (2)

Selected digital input is sent – full range or filtered via the DSP - to the Digital Output connector for daisy-chaining more than one TDA-2200. The sample rate is fixed at 96 kHz. This output is also active when Analog input is selected.

DIGITAL INPUT 4 (3)

XLR Connector for AES input

OPTICAL DIGITAL INPUT 5 (4)

Connector for Toslink input

ANALOG OUTPUT (5)

DAC output from DSP Section

NOTE! The connectors from 6-10 are only available if the optional AD-Converter card is mounted

INPUT (6-8)

Single-ended Analog input L/R pairs 1-3

INPUT (9-10)

Balanced Analog input L/R number 4

LOUDSPEAKER TERMINALS (11)

Loudspeaker output, NOTE! All Outputs are bridged and must never be connected to ground because of the DC offset to Chassis

12

Image 12
Contents RoomPerfect Page Table of Contents RoomPerfect Advanced Menu a. Explanation of graphical symbols i.Exclamation symbolii.Lightning symbol 1. WARNINGSb. Important safety instructions a. Accessories 2. Unpacking the TDA3.Product Registration b. Operating Voltage4. Introduction 5. Front Panel a. ControlsFig 1 TDA 2200 front panel b. Display Indicators 6. Rear Panel Fig 2 TDA 2200 rear panel7. Remote Control 8. Menu System a. RoomPerfect b. Voicingc. Crossover d. Delay e. ADC Level - Otional f. Communicationh. Remote Control g. Trigger Set-upi. Display j. Volume k. Advanced set-up 9. RoomPerfect a. The Guided Set-up- a Quick Guide b. Setting the measurement volume level Fig 3 Measurement of main listening positionPage c. Focus Measurement d. Room Measurements e.Adding more room measurements f.Calculation of Focus 1 and Global Filters 10. RoomPerfect Advanced Menu a. Selected Positionb. Adding a New Focus Position Press enter to continue c. Adding a New Room Position d. RoomKnowledge Index e. RoomCorrection Index11.Daily Use of RoomPerfect a. Global Listeningb. Focus Listening 12. RoomPerfect Troubleshooting b. Fault - No signala. No microphone connected c. Fault - Signal clipping d. Fault - Low signalFig 5 Software Upgrade Tool 13. Software14. Connectors a. Mains Connectorb. Loudspeaker Connectors 16. Cleaning and Maintenance c. Trigger connector15. Optional AD Converter Board a. Balanced inputs17. Technical Specifications a. Audio ParameterValue b. Protection c. Mainsd. Trigger e. Mechanical18. Technical Assistance a. SupportLyngdorf Audio 19. Appendix a. Menu Treeb. Voicing Curves SoftOpen Desharp1