Lyngdorf Audio TDA 2200 owner manual Unpacking the TDA, a. Accessories

Page 7

2. Unpacking the TDA 2200

Carefully remove the unit and accessory kit from the carton, visually check for shipping damage. Contact both the shipper and Lyngdorf Audio immediately if the unit bears any sign of damage from mishandling. All Lyngdorf Audio equipment is carefully inspected before leaving our factory.

KEEP SHIPPING CARTON AND PACKING MATERIALS for future use or in the unlikely event that the unit needs servicing. If this unit is shipped without the original packing, damage could occur and void the warranty.

a. Accessories

You should find the following in the accessory kit:

1.One mains cord

2.Customer registration form

3.Remote control

4.Programming cable

5.Microphone

6.Microphone stand with Mic clamp

7.200 mm (7.9 in) Mic cable

8.8 m (26.25 feet) XLR – XLR cable

7

Image 7

Contents RoomPerfect Page Table of Contents RoomPerfect Advanced Menu 1. WARNINGS a. Explanation of graphical symbolsi.Exclamation symbol ii.Lightning symbolb. Important safety instructions 2. Unpacking the TDA a. Accessoriesb. Operating Voltage 3.Product Registration4. Introduction a. Controls 5. Front PanelFig 1 TDA 2200 front panel b. Display Indicators Fig 2 TDA 2200 rear panel 6. Rear Panel7. Remote Control 8. Menu System b. Voicing a. RoomPerfectc. Crossover d. Delay f. Communication e. ADC Level - Otionalg. Trigger Set-up h. Remote Controli. Display j. Volume k. Advanced set-up 9. RoomPerfect a. The Guided Set-up- a Quick Guide Fig 3 Measurement of main listening position b. Setting the measurement volume levelPage c. Focus Measurement d. Room Measurements e.Adding more room measurements f.Calculation of Focus 1 and Global Filters a. Selected Position 10. RoomPerfect Advanced Menub. Adding a New Focus Position Press enter to continue c. Adding a New Room Position e. RoomCorrection Index d. RoomKnowledge Indexa. Global Listening 11.Daily Use of RoomPerfectb. Focus Listening b. Fault - No signal 12. RoomPerfect Troubleshootinga. No microphone connected d. Fault - Low signal c. Fault - Signal clipping13. Software Fig 5 Software Upgrade Toola. Mains Connector 14. Connectorsb. Loudspeaker Connectors a. Balanced inputs 16. Cleaning and Maintenancec. Trigger connector 15. Optional AD Converter BoardParameter 17. Technical Specifications a. AudioValue e. Mechanical b. Protectionc. Mains d. Triggera. Support 18. Technical AssistanceLyngdorf Audio a. Menu Tree 19. AppendixDesharp1 b. Voicing CurvesSoft Open