Lyngdorf Audio owner manual Connecting the DPA-1, Connecting to sources and ampliﬁers

Page 12

Connecting the DPA-1

Connecting to sources and ampliﬁers

The DPA-1 is very simple to hook up.

1.Connect all sources to the DPA-1.

Then connect the DPA-1 output signal to a powerampliﬁer.

Source(s)

DPA-1Digital Pre-Amplifier

DPA-1

Poweramp

12

Image 12

Contents DPA-1 Page Table of Contents Operating Voltage Unpacking the DPA-1Serial Number Registration Introduction Accessories Front Panel ControlsDisplay Indicators Rear PanelPage Remote Control Page Connecting the DPA-1 Connecting to sources and ampliﬁersUsing Main and Line outputs Menu System Navigating the Menu SystemMenu Tree This is an overview of the entire DPA-1 menu structureIntroduction to RoomPerfect Global ListeningFocus Listening VoicingGuided Setup RoomPerfectSetting the Measurement Volume Level Focus Measurement Room MeasurementsAdding more Room Measurements Calculation of Focus 1 and Global Filters Advanced Options Measure Focus PosMeasure Room Pos RoomKnowledge RoomCorrectionDisplay Timeout Volume Disp. TimeoDisplay Disp. BrightnessVolume Def. VolMax. Vol Input Name Input SensitivityAdvanced Setup Main Out Main Out ControlMain Out Level Line OutRouting Crossover FrequencyDelay Filter TypeTrigger Setup Remote ControlFactory Reset Firmware VersionsRoomPerfect Troubleshooting Firmware Upgrading Connectors Cleaning and MaintenanceTechnical Speciﬁcations AudioProtection MainsTrigger MechanicalTechnical Assistance Appendix Voicing Curves