Lyngdorf Audio owner manual Operating Voltage, Unpacking the DPA-1, Serial Number Registration

Operating Voltage

The DPA-1 can be switched between 115V and 230V mains voltage.

In 115V mode the DPA-1 requires a mains voltage of 100V-120V at 50-60Hz.

In 230V mode the DPA-1 requires a mains voltage of 220V-240V at 50-60Hz.

The mains voltage setting for your DPA-1 can be changed on the rear selector.

Make sure the rear selector is in the correct setting and connect the power input only to the appropiate AC source. The warranty will not cover any damage caused by connecting to the wrong type of AC mains.

The DPA-1 has three power modes:

1.OFF

No circuitry is powered. Please note that some parts of the mains entry section still carry live mains.

2.STANDBY

The microprocessor is active.

3.ON

All circuits are active.

Unpacking the DPA-1

Carefully remove the unit and accessory kit from the carton, visually check for shipping damage. Contact both the shipper and your Lyngdorf Audio representative immediately if the unit bears any sign of damage from mishandeling. All Lyngdorf Audio equipment is carefully inspected before leaving our factory.

Keep shipping carton and packing material for future use or in the unlikely event that the unit needs servicing. If this unit is shipped without the original packing, damage could occur and void the warranty.

Serial Number Registration

Please record the serial number of your DPA-1 here for future reference. The serial number is printed on the label on the rear panel. You will need this serial number, should you ever require service for your DPA-1.

DPA-1 serial number: _____________________

4