Lyngdorf Audio DPA-1 owner manual Display Timeout, Disp. Brightness, Volume Disp. Timeo

Page 24

Display

The sub menus accessible in the Display menu are:

Display

Display Timeout

Disp. Brightness

Volume Disp.Timeo.

Display Timeout

Display Timeout set-up is used for enabling/disabling the 10 sec. display ’switch’off’ feature. If enabled the Main Display reading will switch off after 10 sec of inactivity from the remote control or front panel buttons.

Disp. Brightness

Display Brightness is used to control the brightness of the display. The brightness can be set to 25%, 50%, 75% or 100%.

Volume Disp. Timeo.

If Volume Display Timeout is enabled the Volume Display reading will switch off after 10 sec of inactivity from the remote control or front panel buttons.

24

Image 24

Contents DPA-1 Page Table of Contents Operating Voltage Unpacking the DPA-1Serial Number Registration Introduction Accessories Front Panel ControlsDisplay Indicators Rear PanelPage Remote Control Page Connecting the DPA-1 Connecting to sources and ampliﬁersUsing Main and Line outputs Menu System Navigating the Menu SystemMenu Tree This is an overview of the entire DPA-1 menu structureIntroduction to RoomPerfect Global ListeningFocus Listening VoicingGuided Setup RoomPerfectSetting the Measurement Volume Level Focus Measurement Room MeasurementsAdding more Room Measurements Calculation of Focus 1 and Global Filters Advanced Options Measure Focus PosMeasure Room Pos RoomKnowledge RoomCorrectionDisplay Timeout Volume Disp. TimeoDisplay Disp. BrightnessVolume Def. VolMax. Vol Input Name Input SensitivityAdvanced Setup Main Out Main Out ControlMain Out Level Line OutRouting Crossover FrequencyDelay Filter TypeTrigger Setup Remote ControlFactory Reset Firmware VersionsRoomPerfect Troubleshooting Firmware Upgrading Connectors Cleaning and MaintenanceTechnical Speciﬁcations AudioProtection MainsTrigger MechanicalTechnical Assistance Appendix Voicing Curves