Lyngdorf Audio DPA-1 owner manual Protection, Mains, Trigger, Mechanical

Page 36

Protection

Parameter	Value	Note

Grounding	Mains earth, chassis and audio
	ground are connected internally.
Over temperature	Mains-transformer.	Auto resetting thermal fuse in
		mains transformer.

Mains

Parameter	Value	Note
Mains input connector	IEC 320 cold type	Mains lead supplied.
Mains voltage range	100-240V AC, 50–60Hz
Power consumption	4 W	STANDBY mode.
Power consumption	35 W	OPERATE mode

Trigger

Parameter	Value	Note
Trigger Out connector	3.5mm (1/8”) mono jack	Case=Gnd, Tip=Input
Trigger Out voltage	12V DC	Short circuit protected
Trigger Out Current	50mA

Mechanical

Parameter	Value	Note
Width	450mm (17.72”)
Depth	440mm (17.32”)
Height	100mm (3.94”)	Including feet.
Net weight	7.4Kg (16lb.)
Shipping weight	10.8Kg (23.8 lb.)	Two shipping boxes.

36

Image 36

Contents DPA-1 Page Table of Contents Operating Voltage Unpacking the DPA-1Serial Number Registration Introduction Accessories Front Panel ControlsDisplay Indicators Rear PanelPage Remote Control Page Connecting the DPA-1 Connecting to sources and ampliﬁersUsing Main and Line outputs Menu System Navigating the Menu SystemMenu Tree This is an overview of the entire DPA-1 menu structureIntroduction to RoomPerfect Global ListeningFocus Listening VoicingGuided Setup RoomPerfectSetting the Measurement Volume Level Focus Measurement Room MeasurementsAdding more Room Measurements Calculation of Focus 1 and Global Filters Advanced Options Measure Focus PosMeasure Room Pos RoomKnowledge RoomCorrectionDisplay Timeout Volume Disp. TimeoDisplay Disp. BrightnessVolume Def. VolMax. Vol Input Name Input SensitivityAdvanced Setup Main Out Main Out ControlMain Out Level Line OutRouting Crossover FrequencyDelay Filter TypeTrigger Setup Remote ControlFactory Reset Firmware VersionsRoomPerfect Troubleshooting Firmware Upgrading Connectors Cleaning and MaintenanceTechnical Speciﬁcations AudioProtection MainsTrigger MechanicalTechnical Assistance Appendix Voicing Curves