Lyngdorf Audio DPA-1 owner manual Volume, Def. Vol, Max. Vol

Page 25

Volume

The sub menus accessible in the Volume menu are:

Volume

Def. Volume

Max. Volume

Def. Vol.

The Default Volume setting controls the default volume at start-up and can be set from 0 to 99 dB. However, a setting over 88 is not recommended as this corresponds to max output with full scale digital input.

Max. Vol.

The Maximum Volume setting is a safety precaution used for limiting the maximum volume which can be achieved by spinning the wheel or increasing volume via the remote. This can be set to avoid excessively loud sound pressure levels and/or to protect your loudspeakers against overload.

25

Image 25

Contents DPA-1 Page Table of Contents Unpacking the DPA-1 Operating VoltageSerial Number Registration Introduction Accessories Controls Front PanelRear Panel Display IndicatorsPage Remote Control Page Connecting to sources and ampliﬁers Connecting the DPA-1Using Main and Line outputs Navigating the Menu System Menu SystemThis is an overview of the entire DPA-1 menu structure Menu TreeGlobal Listening Introduction to RoomPerfectFocus Listening VoicingRoomPerfect Guided SetupSetting the Measurement Volume Level Room Measurements Focus MeasurementAdding more Room Measurements Calculation of Focus 1 and Global Filters Measure Focus Pos Advanced OptionsMeasure Room Pos RoomCorrection RoomKnowledgeVolume Disp. Timeo Display TimeoutDisplay Disp. BrightnessDef. Vol VolumeMax. Vol Input Sensitivity Input NameAdvanced Setup Main Out Control Main OutMain Out Level Line OutCrossover Frequency RoutingFilter Type DelayRemote Control Trigger SetupFactory Reset Firmware VersionsRoomPerfect Troubleshooting Firmware Upgrading Cleaning and Maintenance ConnectorsAudio Technical SpeciﬁcationsMains ProtectionTrigger MechanicalTechnical Assistance Voicing Curves Appendix