BridgeWave AR60X manual Environmental

Page 12

AR60X Installation Manual

suppressor. The surge suppressor must be installed at the point where the DC electrical cable exits/enters the building, however, the use of a surge suppressor at the radio unit is optional since power cable surge suppression is built into the unit.

If a copper Cat5 Ethernet cable is permanently installed, it is necessary to install surge suppressors at both ends of this cable. A surge suppressor must be placed within the radio enclosure (to protect the radio electronics) and at the building exit/entrance (to protect the indoor equipment).

For more information on recommended accessory devices and kits, contact BridgeWave Sales

2.8 Environmental

The structure to which the equipment will be mounted must be adequate to bear all wind and weather conditions. The wind load at high wind velocities can exceed 100 ft/lb of torque, BridgeWave highly recommends pole diameters of 3” or more. The environmental conditions at the location must conform to the operating environment specified for the equipment.

580­00517, rev B

6

Image 12
Contents AR60X Wireless Ethernet Links Copyright Notice & Disclaimer Export ControlProduct Compatibility Safety Equipment Precautions Regulatory InformationTable of Contents Introduction Purpose of ManualPrior Knowledge Return Material Authorization RMA Contact InformationEquipment Checklist Site PlanningGeneral Line of Sight LOSLink Distance Antenna LocationCabling ­3 14­gauge DC power cable with crimp connectors Grounding & LightningEnvironmental Cabling Diagram Installation Equipment UnpackingEquipment Inventory Qty DescriptionInstallation Tools Antenna Mount Installation Tighten bolts SecurelyTighten bolts securely AR60X Installation Manual Antenna and Radio Installation ­9 Captive radio bolt detail ­10 Attaching the radio to the back of the antenna ­12 Elevation up/down adjustment Cable Installation Fiber CablingOptional Copper Ethernet Cabling Ground Cabling Ice Shield Canopy Installation IntroductionQty Description AR60X Installation Manual Antenna Alignment Auto Calibration States ­10 Quality Voltage Graph 10QUAL and RSL Test Cable Radio Link Status Indicators Connecting Network Equipment Network Port StatisticsAppendix a Troubleshooting Contact BridgeWave support to obtain a login accountAR60X Installation Manual Appendix B RSL Voltage vs. Distance DistanceStd. Limited Warranty & SW License Limited Hardware WarrantyLimitation of Remedy and Liability Provisions