BridgeWave manual AR60X Installation Manual

Page 37

AR60X Installation Manual

RSL voltage lower

Incorrect calculation of link

Verify that the calculation tool

then expected

distance

used and the GPS used both use

 

 

the same annotation system

 

 

(degree hours minutes seconds

 

 

or degree with a decimal value)

 

Antennas aligned on side

Realign antenna to main lobe.

 

lobes

Keep in mind that the side lobe

 

 

is only 1 degree from the main

 

 

lobe.

 

Antennas set to different

Verify that both radios are set to

 

polarizations

the same polarization. (see

 

 

Section 3.6)

 

Installed two high or low

Verify that one end of the link is

 

band radios in one link

high and the other end is a low

 

 

band radio (see Section 3.6)

 

Link exceeds maximum

Verify that maximum path

Low link quality

specified range

length has not been exceeded

 

 

voltage

Antennas are not aligned for

Verify antenna alignment, using

 

maximum RSL

instructions provided in section

 

 

3.6.

 

Auto­calibration not

Power cycle units to force auto

 

completed

calibration cycles. (see Section

 

 

3.8)

 

Interference

Check for possible interference

 

 

byturning off the radio at the

 

 

other end of the link and verify

 

 

the RSL voltage on the local

 

 

side drops below 0.2V

Wireless link

Network equipment

Verify settings on network

established but no data

configuration and radio

equipment to be consistent with

transfer over the link

configuration incompatible

radio units fiber port settings.

 

 

Verify network equipment port

 

 

configured to not enter error­

 

 

disable state due to link

 

 

up/down transitions

 

 

(see Section 4.1)

31

580­00517, rev B

Image 37
Contents AR60X Wireless Ethernet Links Export Control Copyright Notice & DisclaimerProduct Compatibility Safety Regulatory Information Equipment PrecautionsTable of Contents Purpose of Manual IntroductionPrior Knowledge Contact Information Return Material Authorization RMASite Planning Equipment ChecklistGeneral Line of Sight LOSAntenna Location Link DistanceCabling Grounding & Lightning ­3 14­gauge DC power cable with crimp connectorsEnvironmental Cabling Diagram Equipment Unpacking InstallationQty Description Equipment InventoryInstallation Tools Tighten bolts Securely Antenna Mount InstallationTighten bolts securely AR60X Installation Manual Antenna and Radio Installation ­9 Captive radio bolt detail ­10 Attaching the radio to the back of the antenna ­12 Elevation up/down adjustment Fiber Cabling Cable InstallationOptional Copper Ethernet Cabling Ground Cabling Introduction Ice Shield Canopy InstallationQty Description AR60X Installation Manual Antenna Alignment Auto Calibration States ­10 Quality Voltage Graph 10QUAL and RSL Test Cable Radio Link Status Indicators Network Port Statistics Connecting Network EquipmentContact BridgeWave support to obtain a login account Appendix a TroubleshootingAR60X Installation Manual Distance Appendix B RSL Voltage vs. DistanceLimited Hardware Warranty Std. Limited Warranty & SW LicenseLimitation of Remedy and Liability Provisions