Pioneer AVIC-N3 installation manual Installing the GPS antenna, Installation notes

Models: AVIC-N3

1 61
Download 61 pages 60.83 Kb
Page 27
Image 27

Installing the GPS antenna

Do not cut the GPS antenna lead to shorten it or use an extension to make it longer. Altering the antenna cable could result in a short circuit or malfunc- tion and permanent damage to the product.

Installation notes

English

The antenna should be installed on a

level surface where radio waves will be blocked as little as possible. Radio waves cannot be received by the anten- na if reception from the satellite is blocked.

Installation on the vehicle roof or trunk lid is recommended to optimise recep- tion.

Roof

Trunk lid

Rear shelf

Español

Deutsch

When installing the GPS antenna inside the vehicle, be sure to use the metal sheet pro- vided with your system. If this is not used, the reception sensitivity will be poor.

Do not cut the accessory metal sheet. This would reduce the sensitivity of the GPS antenna.

Take care not to pull the antenna lead when removing the GPS antenna. The magnet attached to the antenna is very powerful, and the lead may become detached.

The GPS antenna is installed with a magnet. When installing the GPS antenna, be care- ful not to scratch the vehicle body.

When installing the GPS antenna on the outside of the vehicle, always put it in the vehi- cle when going through an automatic vehicle wash. If it is left on the outside it may be knocked off and scratch the vehicle body.

Do not paint the GPS antenna, as this may affect its performance.

Français Italiano

Nederlands

26

Page 27
Image 27
Pioneer AVIC-N3 installation manual Installing the GPS antenna, Installation notes