AR60X Installation Manual
It is very important that the azimuth bolts are tightened before any elevation adjustment is done. The very narrow beamwidth of this antenna (0.6º) makes it necessary to completely tighten the bolts of the azimuth adjustment while adjusting the elevation and vice versa.
8. Adjust elevation (up down)
1. Loosen (2) antenna 
mounting bolts
2. Rotate Elevation 
adjust hex nut as required to set correct elevation.
3. Tighten all bolts after the elevation is set.
Figure 312 Elevation (up/down) adjustment
Begin the alignment process with the antenna in a level attitude. When adjusting elevation, it is better to start in a low attitude and raise the antenna to the proper position than to start high and work towards a low elevation setting.
17 | 58000517, rev B |