BridgeWave SLE100 installation manual Cable Installation

TM

SLE100 Installation Manual

3.6Cable Installation

1.Install grounding for the radio unit. The preferred method for grounding the radio unit is to ground the mast (or wall-mount bracket) to a ground source, since this provides the largest grounding surface contact possible. If this is not possible, then use the following procedure:

A.Attach the lug of a 10 AWG ground cable to the radio at one of the two #8 holes at the bottom of the enclosure using a #8-32 bolt, #8 lock washer and #8 flat washers (not provided).

B.Connect other end of the ground cable to a nearby building exterior ground location.

2.Run a Cat 5 cable from the SLE100 radio unit to the indoor location where the PoE Injector will be installed.

3.Connect the Cat 5 cable to the interface labeled “PoE” on the radio unit.

4.Install the PoE Injector in the desired indoor location and connect the Cat 5 cable coming from the radio unit to the interface labeled “Data & PWR”.

19 590-00532, rev A