BridgeWave SLE100 installation manual Antenna Alignment

Page 29

TM

SLE100 Installation Manual

3.8 Antenna Alignment

1.Tighten the mounting bracket azimuth and elevation lock bolts just enough to allow the radio to pivot up/down and right/left with minimal effort. Tilt the radio so that it roughly points towards the other end of the link.

2.Thread the Visual Alignment Tool (VAT) into one of the four holes in the front (antenna) face of the radio so that the o-ring just touches the radio face. The VAT is used to roughly orient (align) the radio in the correct direction. Select the hole that allows the most convenient viewing of the other end of the link. The best viewing is achieved with your eye about 13 inches (33cm) from the VAT mirror. Move the radio such that it is aimed at the point tangent to the top of the red indicator when all three indicators (green/red/green) are in a line with equal gaps between the indicators.

24

590-00532, rev A

Image 29
Contents SLE100 Fast Ethernet Links Product Compatibility Copyright Notice & DisclaimerExport Control Safety Regulatory Information Equipment PrecautionsTable of Contents Prior Knowledge IntroductionPurpose of Manual Return Material Authorization RMA Technical Assistance and Customer ServiceContact Information BridgeWave SalesSite Planning Equipment ChecklistGeneral Line of Sight LOSCabling Antenna LocationGrounding & Lightning Cabling DiagramEnvironmental Equipment Unpacking InstallationEquipment Inventory Qty DescriptionDescription Qty Installation Tools Wall Mounting Instructions Radio Mount InstallationAttaching the Yoke to the Mounting Bracket Wall Mount Hole Drilling Template Pole Mounting Instructions Pole-Mount Bracket AssemblyAttaching Pole Mount Brackets to Wall Mount Bracket Attaching Pole Mount Brackets and Yoke to Pole Polarization Diamond Orientations Radio InstallationAttaching the Radio to the Yoke Perform steps 1 -3 on both ends of the link Cable Installation SLE100 Installation Manual Introduction Optional Ice Shield Canopy InstallationOptional Kit Installation InstructionsAttaching the Ice Shield Re-install the O bolt Antenna Alignment Mirror Ig h tWrong 11 RSL & Qual Test Leads Qual & RSL Test Cable12 RSL and Quality Test Cable Connection Point 14 Radio Link Up and Power LED’s Network Port Statistics Configuring Network EquipmentProblem Possible Cause Resolution Appendix a TroubleshootingSLE100 Installation Manual Appendix B RSL Voltage vs. Distance Limited Hardware Warranty Std. Limited Warranty & SW LicenseLimitation of Remedy and Liability Provisions