TM
SLE100 Installation Manual
Radio at far end of link
Aiming Too low
Wrong
6.Verify Link Up LED’s are lit solid on both radios.
7.Slightly rotate each radio up/down and left/right to find the maximum RSL voltage reading. [Note that the width of the center beam is only 1.4 degrees and the first
Verify that the RSL voltage falls within the expected range based on the graph in Appendix B.
8.Begin to tighten the mounting bolts. It is important to tighten the bolts in the following order. First start with the bolts that control the left/right movement of the radio. These are the bolts on the yoke portion of the mount behind the radio. Start by tightening the bolt closest to the pole or wall. Once this is tightened, move to the bolt directly in front of the bolt you just tightened and slowly tighten this bolt. While tightening the bolts be careful that the radio does not move during the process. As these bolts are tightened up/down movement of the radio may occur due to the seating of the mounting bracket and radio yoke. Check the RSL voltage reading to ensure it is still at its maximum level, and adjust vertical tilt if required. Next, tighten the bolts that allow the up/down movement of the radio. First tighten the lower bolts on both sides of the yoke bracket. Once the lower bolts are tightened on both sides of the radio, tighten the upper bolts.
9.Repeat steps 1 to 8 for the peer radio.
10.Connect to the web management interface of each unit and perform an
11.After both ends of the link are calibrated check the quality voltage using the test cable and a voltmeter and confirm it indicates 3.3V on each end of the link (i.e., error free).
12.Remove the VAT from the radio, replace the back plastic cover and hand tighten the back cover nut to the point where the back cover stops (i.e., when it hits the metal ring on the back metal plate). The installation is now complete.
26 |