Blade ICE manual Port Trunking Example, Follow these steps on the G8000

RackSwitch G8000 Application Guide

Port Trunking Example

In the example below, three ports are trunked between two switches.

	Trunk 3: Ports 2, 23, and 30
	2
23	30

	Trunk 1: Ports 1, 7, and 32
1	7
	32

Figure 4-1Port Trunk Group Configuration Example

Prior to configuring each switch in the above example, you must connect to the appropriate switch’s Command Line Interface (CLI) as the administrator.

NOTE – For details about accessing and using any of the menu commands described in this example, see the Command Reference.

1.Follow these steps on the G8000:

(a)Define a trunk group.

RS G8000 (config)# portchannel 3 member 2,23,30

RS G8000 (config)# portchannel 3 enable

(b)Verify the configuration.

#show portchannel

Examine the resulting information. If any settings are incorrect, make appropriate changes.

BMD00041, November 2008 Chapter 4: Ports and Trunking „ 67