AVE VSI-Pro Max operation manual In-System Programming Display

PROGRAMMING

Second, you go to the menu of the VSI-Pro Max “Download/Upload Setup” then select ==> “Update Firmware” and then press Set. Now you will see message in Hyper Terminal.

Figure 100: In-System Programming Display

“Do you want to update? [Y/N]” Press “Y” to accept update.

You will see message warning again.

“Doing this will erase the program memory [Y/N]” Press “Y” again to accept update.

NOTE: Pressing “Yes” again will permanently erase the entire program memory and the VSI-Pro will not function until firmware is loaded. Make sure you have the proper firmware file ready or the VSI-Pro will be rendered useless.

Finish erasing the program memory step.

Next, you have to send file to update firmware by click on “Transfer Menu” and select “Send Text File” and wait until finished programming. Progress dots will be displayed on the terminal program until finished and takes approximately 2.5 minutes.

NOTE: If for some reason you are disconnected from the VSI-Pro during downloading, power is lost to the VSI- Pro Max or PC or the firmware update does not finish for any reason you can repeat the procedure above again. The bootstrap loader never is erased and will always request for a valid firmware update until achieved.

To do this just power up the VSI-Pro Max or press reset while the terminal program is connected and you will see the prompt messages as above window.

VSI-Pro Max POS / Cash Register Interface

58