AVE VSI-Pro Max AVE POS Networking Protocol VSI-ADD Protocol, ESC Addr Text to be Displayed

Page 75

APPENDIX M

MASTER PROTOCOL

AVE POS Networking Protocol

(VSI-ADD Protocol)

The AVE VSI-Pro Max, IF ECR Interface Cards and other POS Adapters export the POS data in formatted ASCII text via RS-232 directly. This data can be read by any DVR Com Port for recording as a separate data file appended to the Audio/Video file.

For multiple POS on one DVR you could use multiple RS-232 ports but this is cumbersome and the length of runs is limited.

The VSI-Pro Max in the Slave mode or the “Regcom” device connects directly to any of the AVE POS interfaces listed above or any RS-232 source. This buffered device takes the POS data and converts it to an RS-485 network.

The “Networker” connects only to the older VSI-Pro and supports the same RS-485 network. This network is terminated by a “Hydra” or a VSI-Pro Max in the Master mode which decodes the RS- 485 network and sends all the data to one RS-232 Com Port on the DVR.

The data from the Master device to the DVR Com Port has the following data format:

<ESC> ADDR {TEXT TO BE DISPLAYED}

Where ESC is 1BH; ADDR is one byte binary code. The valid address is 1 through 16.

The DVR will then read this protocol and decode the proper POS interface data to be associated with the respective camera.

Network Protocol

For advanced interfacing a DVR may directly control the RS-485 Regcom Network by implementing the full poll/select protocol. For more information on this contact the AVE factory.

The latest in the development of RS-485 networking is called the Vnetworker Protocol. This is an enhanced poll/select protocol that allows the remote master to program and control the remove VSI-Pro Max or VSI-Pro with Vnetworker device. Not only will this allow transaction logging but allow reading Alarm inputs, setting/reading/locking to T/D and full programming and register configuration remotely. Implementation of this protocol brings seemless POS /Cash Register / ATM interfacing to the AVE or 3rd party DVR suppliers. For more information on this contact the AVE factory.

VSI-Pro Max POS / Cash Register Interface

75

Image 75
Contents September VSI-PRO MAXVSI-Pro Max Contents Figures Register Select Sub-Menu ContentsRecerve RX Test Sub-Menu VSI / VSI+ / VSI-Pro / VSI-Pro Max Backward Compatibility IntroductionFeatures Features & SpecificationsDTR / DSR SpecificationsConnections LED IndicatorsRTS PIN # Signal Name RS232DTR DSRTo Earth Ground for Surge Suppression PIN # Function DirectionGrounding and Isolation Video Surge / Lightning ProtectionRS-232 DB9F Shielding Down Up Set Reset User Front Panel ControlsFront Panel Controls Changing the Horizontal Position Register Select ProgrammingGetting Started Main Programming MenuTCP/IP Next page ExitTCP/IP Limitations Addressable VSI VSI-ADD Model TK-T500 Mode Emulating ExitMode Emulating Exit GenericJournalprinter Receiptprinter Delta SonoDresser Wayne POS / CDU NucleusPC G-SITE GasboyDevice Console Device Address Exit GilbarcoNCR Source TypeLocal VSS Micros IDN Network Micros ISN Network Exit Device Printer Device Address ANY Modetap ExitNucleus Printer Title Display on Console ID ANY Working Mode ExitWorking Mode TAP Exit NorandSicom Sharp 750 ER-01PUTAP Emulate TAP US Emulate US TAP EmulateTerminal Exit TkmaxUniwell Device Address ANY Address on ExitScreen Setup Text GrayscaleBackground Grayscale Clock Sub-Menu Language English Exit TitlerTitler OFF Exit TitleText Display Choices NONE, 6, 12, 20, 30, 60, 120, 180Display Character / Line Display Left JustificationRS-232 Register Settings Network Settings ExitCommunication Interface TypeChoices ON, OFF Choices ASCII, VSI-ADD, VNet, Dallmeier, MvdrChoices NONE, ODD, Even Choices 7 orChoices GENERIC, MASTER, SLAVE, OFF Type OFF Address Protocol Regcom 9.6K Baud Rate9600 TypeException Report Overview Exception ReportsHard Alarm Output ON-SCREEN FlagsPrinter or DVR Output View Exceptions Total Exception000 Total ExceptionsDest ID SCR ID Exit DMS-3001 DVR-3011,3021 MVDR3000, MVDR5000DVR DB9F VSI-Pro Max DB9MChoices 1 through 00,000,000.00 00,000,000.00Operator None Exit Exception noProgramming Note History Buffer ON/OFFChoices NONE, IN, OUT Negative ExceptionChoices 00,000,000.00-99,999,999.99 OperatorOUT Range EqualGreater than Less thanScroll Matching Triggered Text Video Loss OFF Exit Alarm OutputsScroll Matching Timeout Exit 010Choices no Normally open, NC Normal closed Alarm noChoices 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15 Normal State30S Display Text OFF Output Text RTS Triggered DelayChoices 6, 12, 30, 60, 120, 180 Triggered TextChoices Manual, 1s, 2s, 3s, 4s, 5s, 10s, 20s, 30s, 1M Display TextChoices OFF, 1S, 5S, 10S, 20S, 30S, 1M, 5M, 10M SET Triggered TextReceive RX Test TEST/DEMO ModePort 1 Test Data Capture Register Demo Version ID Exit Port 1 TestRX Baudrate Auto TX Baudrate 2400RX / TX Test Capture to Port Capture to Memory Dump Memory Exit Capture to PortParity None Data BIT Handshaking OFF Baudrate Detection PIN DOWNLOAD/UPLOAD SetupDemo Demo on Power UP OFF Exit DOWNLOAD/UPLOAD Data CableDOWNLOAD/UPLOAD Setup Using VSI-Pro Max to VSI-Pro Max DOWNLOAD/UPLOAD Setup Sub-Menu Download Setup Upload Setup Update Firmware ExitDOWNLOAD/UPLOAD Setup Using a PC Software InstallationVSI-Pro Max Remote Program Downloading Ver Remote Menu Click the Tab Remote and you will see the following MenuPC / Laptop DB9F VSI-Pro DB9M File MenuAbout Menu Communication Cable Pin OutDownload Setup VSI-Pro Firmware Download MenuVSI-Pro Max Firmware Download Utility Connect To Menu In-System Programming Display Appendix a Problem Solving GuideCharacters JITTER, JUMP, or Skew No Network Communication or LED FlashingNo Data to the DVR from Master No Video on MonitorAppendix a Problem Solving GuideVL Video Error LED not on but Video Looks BAD VL Video Error LED on but Video Looks GoodAppendix B Hard Alarm OutputScrew Terminals Appendix CDVR Text Input Connections DVR DB9M DB9FUTP Connections Appendix D AGCVSI-Pro Max RJ45 Pin Outs RJ45 Out RS DB-9F VSI-Pro DB-9M Appendix EP2RS Parallel to Serial Converter Front PanelAppendix F USB to RS-232 ConverterVsib DB-9M VSI-Pro DB-9M Vsib InstallationAppendix G Vsib for Thai, Korean or Chinese LanguagesAnsi Driver Commands Appendix ECR / Tpif Interface CardsAppendix H RS-232 to RS-485/422 Converter PCB Appendix JRXD TXD GND Tcpip 232 Adapter Appendix KTcpip 232 Adapter Tcpip DB-9MVSI-Pro Max Network Capability Appendix LVSI-Pro Max Networking Network Types DVR Master / Hydra Appendix MRS-485 Network Appendix M Master / HydraAVE DVRHydra and Regcom Dipswitch SettingsMaster Protocol AVE POS Networking Protocol VSI-ADD ProtocolESC Addr Text to be Displayed Network ProtocolDVR RS-485 Vnetworker Appendix MRS-485 Vnetworker IntroductionView Status Windows Windows Tile Horizontally Windows Tile VerticallyFiles Remote Keyboard Address SelectAppendix N AL-16 Alarm Output AdapterCash Drawers, Safes and Security Doors Access Control PanelsAppendix O POS & Cctv Applications PTZ ControlLimited Warranty Limited Warranty Appendix PAppendix Q Master ResetLimited Warranty Doing a Master Reset Clears ALL ProgrammingNorth America