5
Menus
This chapter describes each management menu on the IntraStack 6000 Series’s Device Page.
The table below provides a brief description of each menu; the sections that follow explain each menu in detail.
| Table |
|
|
Menu | Description |
|
|
Configuration | Title for the submenus listed below it; this menu cannot be |
| selected. See “Configuration” on page |
|
|
Identify | Allows you to view and configure device identification |
| information. See “Identify” on page |
|
|
Agent | Allows you to view agent information. Also allows you to |
| configure the device’s image load mode, remote boot infor- |
| mation, and |
| “Agent” on page |
|
|
IPAgent | Allows you to view and configure the IP address, default |
| gateway, and boot server address for the device. Also |
| allows you to set the Telnet idle |
| “IPAgent” on page |
|
|
swAgentSW | Allows you to view and configure the information needed |
| for downloading a new image file or configuration file. Also |
| allows you to enable or disable the Spanning Tree Protocol. |
| See “swAgentSW” on page |
|
|
swAgentHW | Allows you to view hardware information on the device’s |
| SNMP agent (such as DRAM and EEPROM size). See |
| “swAgentHW” on page |
|
|
swBasic | Allows you to view basic information (such as the back- |
| plane type and group capacity) on the device or a particular |
| group. See “swBasic” on page |
|
|
Page