Aiwa CX-NA71 manual Setting the Clock, Setting the Timer, #$~A~B&.’z~gl~~,p$Q~ . jV!j@Lgq@@.F=%%@

SETTING THE CLOCK

■1

1,2,3

2,3

1 Press the CLOCK button on the remote control, and press the I I SET button within 4 seconds.

.. %....-

@~~p~~,a@yf~:E~gy*~gBap,s@z~*~bY&.#@&M.-

,,,..,q.,,,~~,& .i%-,&.:L,,=,,.~,.p&k’.u,=~,g~&s-*’@&.,E@Bwe=,e=,Tb- k,. ..@?M&$@B-

#$~A~B&.’z~gl~~,;p$Q~ _ : ::. :“jV!j@Lgq@@.F=%%@&

‘$’-!-’whw%~,%~,,,,:- ,“, *M” -“”%=9+ fu%~i~*g#gE8i$q&**, , $, , , ..... l.- .....!$~$~~~@J*d#m*

@’B18; ,,~~;@-hw&i? mlip,p~g$p~ $@Fqp&#~ib~~~,

,9,,, !“?~iPB~’$#JJ$@#**#l$*$nJ,kik* ~~%

. ~, ,,,,,~jg~~gt ~~~B~~~, ~ M!. ‘@m,*.,,,,8,,eq= zae.,,..::bE;3:6@@’:Ez:td8:kiii!!$.~, “’~”#3

2 Press the 4+ DOWN or ➤F UP button to designate the hour, and press the 11 SET button.

The hour stops flashing and the minute starts flashing.

3 Press the << DOWN or ➤> UP button to designate the minute, and press the II SET button.

The minute stops flashing on the display and the clock starts from 00 seconds.

To display the current time

Press the CLOCK button on the remote control. The time is displayed for 4 seconds.

However, the time cannot be displayed during recording.

TO switch to the 24-hour standard.

Press the CLOCK button on the remote control and then press the ■ button within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes .

This is caused by a power interruption; The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

SETTING THE TIMER

i

,,

2,43

1,2

6

The unit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

Use the remote control.

7 Press the TIMER button once to display 0, and press the II SET button within 4 seconds.

O is displayed, and the hour flashes.

m

If you press the II SET button after 4 seconds, another operation may start.

2 Designate the hour of the timer-on time by pressing the l<< DOWN or WI UP button, and press the 11 SET button. Repeat to designate the minute of the timer-on time.

After you designate the timer-on time, one of the source name

flashes on the display for 4 seconds.

3 Within 4 seconds, press one of the function buttons to select a source.

The selected source name flashes for4 seconds. At this time, the selected function button does not light up,

●If this step is not completed within 4 seconds, repeat from step 1.-

●If the TUNER button is pressed, the band cannot deselected’ in this step.

4 Within 4 seconds, select the duration for the timer-activated period with the 1<4 DOWN or WI