CARE AND MAINTENANCE
Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit,
TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these Operating Instructions, check the following guide,
To clean the cabinet
Use a soft and dry cloth,
If the surfaces are extremely dirty, use a soft cloth lightly
moistened with mild detergent solution, Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.
To clean the heads and tape paths
After every 10 hours of use, clean the heads and tape paths with a head cleaning cassette or cotton swab moistened with cleaning fluid or denatured alcohol. (These cleaning kits are commercially available,)
When cleaning with a cotton swab, wipe the recording/playback head, erasure head (deck 2 only), capstans, and pinchrollers,
1Capstan.“aybackTdcOt’7bcapstan1
I | Erasure | head | P;chroller |
|
| ||
I |
|
|
|
|
| / |
After cleaning the heads and tape paths with a liquid head cleaning cassette or a moistened swab, wait until the cleaned parts are completely dry before inserting the tapes.
To demagnetize the heads
The heads may become magnetized after
Care of discs
●When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.
.- f+,, |
| |
s ~ :, :.1.. |
| |
.: ,,. | .~. . | “~ |
..’ .. |
| |
. . |
|
|
.. . . .
e. : ;“l,.=.’ .: “,
*
e After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.
Care of tapes
●Store tapes in their cases after use.
●Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.
●Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.
GENERAL
There is no sound.
●Is the AC cord connected properly?
●Is there a bad connection?
●There may be a short circuit in the speaker terminals.
+Disconnect, the AC cord, therl correct the speaker connections.
●Was an incorrect function button Dressed?
Sound is emitted from one speake!r only.
●Is the other speaker disconnected?
The output sound is not stereo.
c Is the Karaoke function turned on?
An erroneous display or a malfunction occurs.
+Reset the unit as stated below.
TUNER SECTION
There is constant,
●Is the antenna connected properly? (,+ page 3)
●Is the signal weak?
+Connect an outdoor antenna.
The reception contains noise interferences or the sound is distorted.
●Is the system picking up external noise or multipath distortion?
+Change the orientation of the antenna.
+Move the unit awav from other electrical appliances.
CASSETTE DECK SECTIONI
The tape does not run.
●Is deck 2 in pause mode? (~ page 13)
The sound is
●. Is the playback head dirty?
Recording is not possible.
●Is the erasure prevention tab on the tape broken off? (+ page 14)
●Is the recording head dirty?
Erasure is not [possible.
●Is the erasure head dirty? (+ page 24)
●Is a metal tape being used?
High frequency sound is not emitt(ed.
●Is a tape recorded without Dolby NR played back with the Dolby NR system operating? (+ page 13)
●Is the recording/playback head dirty? (+ page 24)
CD PLAYER SECTION
The CD player atoes not play.
●Is the disc correctly inserted? (+ page 11)
●Is the disc dirty? (+ page 24)
●Is the lens affected by condensation?
+ Wait approximately one hour and try again.
To reset
If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.
1Press the POWER button to turn off the power.
2Press the POWER button to turn the power back on while pressing the ~ CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then repeat step 2.
ENGLISH 24