Aiwa NSX-MT241, CX-NMT240 Timer Recording, Press Timer repeatedly until C!appears on the display

TIMER

3

2

The unit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

1 Press one of the function buttons to select a

source.

If TUNER BAND is pressed, the band cannot be selected in this step.

2 Press TIMER repeatedly until C!)appears on the display.

Time and audio source name flash alternately,

3 Within 6 seconds, turn MULTI JOG to designate the timer-on time, then press ENTER or II.

Turning MULTI JOG changes both the hour and the minute.

+or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

4 Within 4 seconds, turn MULTI JOG to select the duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5- minute steps,

+or > is also available instead of MULTI JOG,

The duration will be automatically set after 4 seconds. it will also be set if ENTER or II is pressed within 4 seconds after step 4.

5	Adjust the volume.	5
	The source sound will play at the volume level set in this step
		,s,
	when the power is turned on by the timer.
		@$j
	If the volume level is set to 21 or higher, however, it will
		et~j.,
	automatically be set to 20 when the power is turned on.
		j?,	~,,,
		.,,&	,,,,.
			).2”;
6	Prepare the source.	*
		‘$$?
	To listen to a CD, load the disc to be played first on tray 1.
	To listen to a tape, insert the tape into deck 1 or 2.	‘q”
	To listen to the radio, tune in to a station.	o
7 Press POWER to turn off the power.
	When the timer-on time is reached: the unit turns on and
	begins play with the selected source,
You can change the source that was selected in step 1 by pressing
one of the function buttons before pressing ENTER or II in step
3.
To check the timer setting
Press TIMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds,
To change any of the previous setting
Carry out from step 1,
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly so that@ disappears.
To restore the timer standby mode, press again to display 0.		❑
Using the unit while the timer is set
You can use the unit normallv after setting the timer.

Before turning off the power, ”carry out st;p 5 and 6.

m

●Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit, Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VI DEO/AUX (with an external timer) sources only.

Press either TUNER BAND or VIDEO/AUX to select a source, then press TIMER repeatedly until 0 REC appears on the display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6.

m

s When the power-economizing mode (page 8) has been turned on, the timer recording volume level will be O (minimum level),

●You cannot use the timer function to record from a CD or tape.

ENGLISH 21