Aiwa CSD-ED87 manual Press *RADIO/BAND repeatedly to select the desired band, Repeat steps 1, Fam

Press *RADIO/BAND repeatedly to select the desired band.

FM + AM

The power is turned on and the previously tuned station is received.

The RADIO indicator lights up.

*or BAND on the remote control (applicable when the AC cord is connected)

Press	l++, -1	(+, - TUNING)	to select a
station.
During	FM stereo	reception, ~	is displayed.

After listening, press POWER (!) STANDBY to turn the power off.

For better reception

FAM

Extend the FM antenna and	The AM antenna is inside
orient it for the best reception.	the unit. Position the unit
	for the best reception.
For quick tuning

Keep -1-, – TUNING pressed until the tuner starts searching for a station. When a station is tuned to, the search stops.

If the broadcast signal is weak, it does not stop. To stop the search manually, press -1- or -.

*REPEAT/FM MODE/OSC

-If an FM stereo broadcast contains noise, press the

button so that - is displayed.

Noise is reduced, although reception is monaural. To restore stereo reception, press the button again.

-If a high-pitched sound is heard during AM recording, press the button repeatedly until the noise is reduced. Its position can be checked by “J’being on or off the display.

*or MODE on the remote control

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the interval as follows.

1 Press RADIO/BAND to display FM.

2Press ■ while pressing RADIO/BAND to display the AM frequency.

When the AM tuning interval is changed, the preset stations are cleared.

I
I	STOPIMEMORY ~
	Q@
	-	TUNING +
	POWERb STANDBY BAND
	TAPE n	RADIO I19J

NOTE

If the unit picks up noise from other electrical appliances nearby, like a TV or fluorescent lights, move the unit.

You can preset up to 15 stations in each band.

1Select a station.

zPress’~ STOP/MEMORY once so that “M” is displayed to store the station,

A station is assigned a preset number, beginning from 1 in consecutive order for each band.

“M”may not be displayed if the button is kept pressed for more than 0.5 second.

Preset number

Fre~uency

*or ❑ on the remote control

gRepeat steps 1 and 2.

The next station will not be stored if a total of 15 preset stations have already been stored for a band.

To listen to preset stations

Select a band then press -11 PLAY/PAUSE/PRESET repeatedly.

-PLAY on the remote control is also available.

To select a preset number directly with the remote control

Press the numbered buttons O-9 and +1 O.

Example:

To select number 15, press +10 and 5.

To select number 10, press +10 and O.

To clear a preset station

Display the preset number first. Then, press I while the preset number is displayed.

The higher numbers in the band are decreased by one.

4ENGLISH