Aiwa CX-NA222 manual Press one of the function buttons to select a source, Adjust the volume

Page 17

z-/

““~heunit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly.

Press one of the function buttons to select a source.

●If TUNER BAND is pressed, the band cannot be selected in this step.

Press TIMER repeatedly until 0 appears on the display.

5

Adjust the volume.

R

 

The source sound will play at the volume level set in this step

 

a.

 

when the power is turned on by the timer.

 

j:~j~

 

If the volume level is set to 17 or higher, however, it will

 

;*4JL

 

automatically be set to 16 when the power is turned on.

 

, ;;l

 

 

1?! ‘+:

 

 

,.,.

 

 

~,., ~’‘8’

6

Prepare the source.

%

;$%;

 

To listen to a CD, load the disc to be played first on tray 1.

,;””~

 

To listen to a tape, insert the tape into deck 1 or 2.

‘1 ,.

 

8

To listen to the radio, tune in to a station.

d

7 Press POWER to turn off the power.

When the timer-on time is reac:hed~ the unit turns on and begins play with the selected source.

You can change the source thlat was selected in step 1 by pressing one of the function buttons before pressing ENTER or II in step 3.

To check the timer setting

Press TIMER.

The selected source, the timer-cm time, and the duration for the timer-activated period will be displayed for 4 seconds.

To change any of the previous setting

Carry out from step 1.

However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily Press TIMER repeatedly so that @ disappears.

To restore the timer standby mode, press again to display ~.

When using the remote control, press TIMER while pressing

SHIFT.

Time and audio source name flash alternately.

a

Using the unit while the timsr i:sset

You can use the unit normally after setting the timer. Before turning off the power, carry out step 5 and 6.

m

m

Within 6 seconds, turn MULTI JOG to designate the timer-on time, then press ENTER or Il.

Turning MULTI JOG changes both the hour and the minute.

+or - is also available instead of MULTI JOG. Holding these buttons down will vary the time rapidly.

Within 4 seconds, turn MULTI JOG to select the duration for the timer-activated period.

The duration can be set between 5 and 240 minutes in 5 minute steps.

-or E iS alSOavailable instead of MULTI JOG.

The duration will be automatically set after 4 seconds. It will also be set if ENTER or 11 is pressed within 4 seconds after step 4.

. Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot Ibeturned on and off by the built in timer of this unit. Use an external timer.

Timer recording is applicable for TUNER and VI DEO/AUX (with an external timer) sources only.

Press either TUNER BAND or VllJEO/AUX to select a source, then press TIMER repeatedly until ~ REC appears on the display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6.

m

You cannot use the timer functicm to record from a CD or tape.

ENGLISH 17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents IilI!i3E English Presetting Stations ~OT Attempt to Service the Unit YourselfSetting the Clock Setting the Sleep Timer Setting the Timer ConnectionsConnect the right and left speakers to the main unit Sta Connect the supplied antennasConnect the AC cord to an AC outlet To use Shift on the remote control When to replace the batteriesTo use Function on the remote control To turn the power onSuper T-BASS System VolumeTo set the tape counter to To select with the remote controlPress * to start play Press Down or UP to select a station Press Tuner Band repeatedly to select the desired bandRepeat steps 1 ~FM-AMTTo play one disc only, press Disc Direct Play Playing DiscsLoading Discs Press numbered buttons 0-9 and +10 to program Track Press Prgm while pressing Shift in stop modePress Disc Direct Play 1-3 to select a disc Press REC/REC Mute to start recording Inserting Blank SpacesInsert the tape to be recorded on into deck To stop dubbing Press Tape Deck 1/2 to select deckPress Sync DUB to StiBrt recording Insert the tape into deck Press REC/REC Mute to start recording on the first sideTo change the program of each side Repeat step For the Irest of the tracks for side ‘,,!lTo check the order of the programmed track numbers Press II or Enter To view the clock when another display is in the displayPress 11 or Enter Press Power to turn off the power Adjust the volumePress one of the function buttons to select a source Prepare the sourceWhen the CD Digital OUT Optical jack is not being used When connecting a turntablePress VIDEO/AUX Play the connected equipmentCD Player Section Cassette Deck SectionAmplifier section Main unit CX-NA222Speaker svstem SX-NA332 For NSX-A222 CabinettypePage Eneraia el%triCa Anotacion del propietarioInstalacion Otras CONEXlONESI Compruebe su sistema y Ios accesorios ImportanteSpeakers L Antes de conectar el cable de alimentacion de CAConecte el cable de alimentacion de CA a una toma de CA Conecte Ias antenas suministradasCuando reemplazar Ias pilas Insertion de las pilasPara utilizar Shift del control remoto Para utilizar Function del control remotoPara disfrutar del juego Para iniciar o detener la demostracion del juegoPara reiniciar el juego Para seleccionar con el control remotoPulse para iniciar la reproduction Pulse Tape y a Push Eject para abrir elPulse + Down o W UP para seleccionar una emisoram Sintonizacion Mediante Nijmero DE PreajusteRepita Ios pasos 1 y Down O UPReproduction DE Discos Introduction DE DiscosPara reproducer un disco soiamente, pulse Disc Direct Play Para comprobar el tiempo restantePulse Disc Direct Play 1-3 para seleccionar un disco Reproduccion ALEATORIA/REPETITION DE ReproductionPulse RANDOM/REPEAT mientras pulsa Shift Insercion DE Espacios SIN Grabar Pulse @ REC/REC Mute para iniciar la grabacion Pulse Tape Deck 1/2 para seleccionar la platinaPara detener el copiado Para detener el copiadoPara borrar el programa de edition Inserte la cinta en la platinaEdit Tiempo de Ias cintas de casete y tiempo de editionPara cambiar el programa de cada cara Pulse 1I o Enter Para cancelar el temporizador para dormirPulse II o Enter Para reponer el ajuste original del relojLa fuente Ajuste el volumenPulse Power para desconectar La alimentacion Haga la reproduction en el equipo conectado Pulse VIDEO/AUXCuando conecte un giradiscos Cuando no se utilice la toma CD Digital OUT OpticalSeccion DE LA Platina GENERALIDADE23Seccion DEL Sintonizador Formatode pistas Gamade sintonizacionRespuestade frecuencia Sistemade grabacionPage Releve du proprietaire InstallationSON EN CAS DE Probleme SpecificationsEgaliseur Graphiqlje Operations DE BaseNSX-A222 Contr61er la chalne et Ies accessoiresAvant de brancher Ie cordon secteur Surround Speakers i?ou LConnexion D’UNE Antenine Exterieure Utilisation de Function de la telecommande Utilisation de Shift de la telecommandeMise en place des piles Quand remplacer Ies pilesPour demarrer ou arr~ter le jeu Demo Pour selectionrer avec la t61ecommandeUtilisation du jeu Demo Pour reinitialiser Ie jeu DemoAppuyer sur b pour demarrer la lecture Appuyer sur Down ou blb UP Dour selectionner une station Accord Sljr UNE Station MemoriseeRepeter Ies etapes 1 et Pour changer I’intervalle d’accord AMLECTUREl!4@*l~SOMPACTS Lecture DE DisquesTouches Disc Direct Play Fonction de lecture directePour changer Ies plages programmers Au sujet des cassettes Inserer la cassette a enregistrer clans la platineAppuyer sur @ REC/REC Mute pour demarrer I’enregistrement ’enregistrement Appuyer sur Tape Deck 1/2 pour selectionner la platineAppuyer sur Sync DUB pour demarrer I’enregistrement Pour arri%er la duplicationDu montage Inserer la cassette clans la platinePour effacer Ie programme du montage Pour arr&er I’enregistrement Repeter I’@tape 5 pour Ie reste des plages de la face AnPour contr~ler I’ordre des numerc~s des plages programmers Pour effacer Ie programme du montagePour retablir un reglage initial de I’horloge Appuyer sur II ou EnterPour passer au format de 24 heures Si I’affichage de I’horloge clignoteSur Power pour mettre I’appareil hors Tension EN Registrement Commande PAR MinuterieRegler Ie volume Pour connecter un tourne-disque Prises VIDEO/AUXQuand la prise CD Digital OUT Optical n’est pas utilisee Optical + VIDEO/AUXGeneralities Un affichage ou un fonctionnement erron~ se produitPartie Tuner Partie MagnetocassetteDroits D’AUTEUR Partie tuner FM Plaged’accordSensibilityutile IHF Page Page Page Wclear Preset Power Tape Deck Tuner Band VIDEO/AUX@ Volume @T-BASS Graphic Equalizer ROCK, POP, Classic Multi Timer ENTER/DIMMER

CX-NA222 specifications

The Aiwa CX-NA222 is a remarkable compact stereo system that combines nostalgic design with modern functionality, making it a perfect addition to both classic and contemporary spaces. Known for its powerful sound output and versatile features, the CX-NA222 appeals to a broad audience of audio enthusiasts.

One of the standout features of the Aiwa CX-NA222 is its high-performance cassette deck, which allows users to enjoy the warmth and authenticity of analog sound. This classic feature is complemented by a CD player that supports various disc formats, providing users with multiple ways to indulge in their favorite music collections. The system also includes a built-in FM/AM tuner with digitally synthesized tuning and pre-set station memory, ensuring users can easily access the radio for news, talk shows, or music.

The sound quality of the CX-NA222 is enhanced by its dual-channel output, delivering rich and crisp audio. With a total RMS power output that is impressive for its size, it produces a dynamic range that is suitable for both soft background music and loud party anthems. The bass boost feature further enhances low frequencies, ensuring that bass lovers will not be disappointed.

In terms of connectivity, the Aiwa CX-NA222 boasts various input options, including an auxiliary input for connecting external devices such as smartphones and tablets. This allows users to enjoy music from digital sources seamlessly, making the system versatile enough to suit modern listening habits. Moreover, the front-panel USB port enables users to play music directly from USB flash drives, adding another layer of convenience.

The design of the CX-NA222 is functional yet stylish, featuring a sleek finish that complements any home décor. Its compact size means it can fit snugly on shelves or desks, while the detachable speaker systems allow for flexible placement around the room. The user-friendly interface, with clearly labeled buttons and a bright LED display, simplifies navigation and operation.

Overall, the Aiwa CX-NA222 represents a perfect blend of vintage charm and cutting-edge technology. Its diverse features, from the cassette deck and CD player to modern connectivity options, elevate it as an ideal choice for anyone looking to relive classic music experiences while enjoying today’s digital audio. With its impressive sound quality and appealing design, the CX-NA222 is a true gem in the realm of compact stereo systems.
Top Page Image Contents