Motorola manual MVME6100 Jumper and Switch Settings, Jumper Switch Function Settings

Chapter 1 Hardware Preparation and Installation

Table 1-2. MVME6100 Jumper and Switch Settings

Jumper/
Switch	Function	Settings
J7	SCON Header	[No jumper installed]	Auto-SCON
		1-2	Always SCON
		2-3	No SCON
J10,	PMC/IPMC Selection Headers	[Jumper installed]
J15–J18,		1-2	PMC I/O
J25–J28		[2-3]	IPMC I/O for IPMC7xx
			support (default)
J30	Front/Rear Ethernet and	Refer to Front/Rear Ethernet and Transition Module
	Transition Module Options	Options Header (J30) on page 8 for details.
	Header
S3	SROM Configuration Switch,	Refer to SROM Configuration Switch (S3) on page
	sets board Geographical	8 for details.
	Address
S4	Flash Boot Bank Select	Refer to Flash Boot Bank Select Configuration
	Configuration Switch, sets	Switch (S4) on page 9 for details.
	Write Protect A, Write Protect
	B, Boot Bank Select, and Safe
	Start

Note Items in brackets are factory default settings.

MVME6100 Installation and Use (V6100A/IH2) 5