Internet Service: Install the Cable Modem, Continued
Installing the Modem for High-Speed Data Service
The following installation procedures explain how to set up and configure your cable modem if you plan to use
WARNING: To avoid personal injury or damage to your equipment, follow these steps in the exact order shown.
Follow these steps to install your modem for
1.Power off your PC and unplug it from the power source.
2.Connect your PC to either the Ethernet port or the USB port using the appropriate data cable.
Note: You can connect two separate PCs to the cable modem at the same time by connecting one to the Ethernet port and one to the USB port.
3.Insert the AC power adapter cord into the DC power connector on the back of the cable modem, and then plug the power adapter into an AC power source.
4.Plug in and power on your PC.
5.Connect one or both of the telephone ports to your home telephone jack(s), or plug a telephone directly into one of the telephone ports.
6.Connect the active RF coaxial cable to the CABLE IN connector.
Note: Use an optional cable signal splitter to add a TV, a DHCT or
7.The cable modem will then begin an automatic search to locate and sign on to the broadband data network.
Note: This process may take up to 5 minutes. The modem will be ready for use when the CABLE light on the front panel stops blinking and illuminates continuously.
8.Your next step is to configure the modem. Choose one of the following options:
•To configure the TCP/IP protocol for Ethernet, go to Configure TCP/IP, next in this guide.
•To install the USB Drivers for USB, go to Install USB Drivers, later in this guide.
18 | WebSTAR DPX2203 or EPX2203 VoIP Cable Modem User’s Guide | 4004041 Rev A |