Scientific Atlanta EPX2203, DPX2203 manual Microsoft Windows

Page 25

Internet Service: Install USB Drivers, Continued

Microsoft Windows 2000

Follow these steps to install the WebSTAR cable modem USB drivers for Microsoft Windows 2000 environments.

1.Insert the USB Cable Modem Driver Installation Disk into the CD-ROM drive of your PC.

2.Wait until the POWER and CABLE lights on the cable modem appear solid green; then, plug the USB cable into the USB port on your PC.

Result: The Found New Hardware Wizard window opens.

3.In the Found New Hardware Wizard window, click Next.

4.In the Found New Hardware Wizard window, select Search for a suitable driver for my device (recommended), then click Next.

5.In the Found New Hardware Wizard window, select CD-ROM drives, and then click Next.

6.In the Found New Hardware Wizard window, click Next.

Result: The system searches for the driver file for your hardware device.

7.After the system finds the USB driver, the Digital Signature Not Found window opens displaying a confirmation message to continue the installation.

8.Click Yes to continue the installation.

Result: The Found New Hardware Wizard window reopens with a message that the installation is complete.

9.Click Finish to close the Found New Hardware Wizard window.

Result: The USB drivers are installed on your PC and your cable modem is ready for use.

Note: If you cannot access the Internet, contact your cable service provider for further assistance.

Continued on next page

24

WebSTAR DPX2203 or EPX2203 VoIP Cable Modem User’s Guide

4004041 Rev A

Image 25

Contents WebSTAR DPX2203 EPX2203 VoIP Cable Modem User’s Guide Introduction OverviewThis Guide This Section Important Rules for Safe OperationPlacement Cleaning the EquipmentRead and Retain These Instructions Important Rules for Safe Operation Power Sources Power Cord ProtectionDamage that Requires Service GroundingSection B Before You Begin Check Your Equipment Equipment ChecklistSection C Front and Back Panel Components Front Panel Components WebSTAR Cable Modem Front PanelBack Panel Components WebSTAR Cable Modem Back PanelFunctions of the Front Panel Lights Initial Power Up, Calibration, and RegistrationFront Panel Lights During Normal Operations Normal OperationsFront Panel Lights During Special Conditions Special ConditionsInternet Service Overview Section D Internet Service InstallationContacting Your Local Cable Service Provider Internet Service Before You BeginSelecting a Location for Your Modem Minimum System Requirements for PCs Internet Service System RequirementsInstallation Diagram Internet Service Install the Cable ModemInstalling the Modem for High-Speed Data Service Microsoft Windows 95, 98, 98SE, and ME Internet Service Configure TCP/IPResults Microsoft Windows XP Microsoft WindowsMacintosh Microsoft Windows 98, 98SE, or ME Internet Service Install USB DriversMicrosoft Windows Microsoft Windows XP Frequently Asked Questions Internet Service Frequently Asked QuestionsCommon Troubleshooting Suggestions Internet Service TroubleshootingCheck and Correct Telephone Service Overview Section E Telephone Service InstallationTelephone Service Before You Begin Selecting a Location for Your Modem Telephone Wiring Requirements Telephone Service Telephone RequirementsNumber of Telephone Devices Telephone Device TypesInstalling the Cable Modem to Provide Telephone Service Telephone Service Install the Cable ModemInstallation Diagram Installing the Cable Modem Can I use my existing phone number with the cable modem? Telephone Service Frequently Asked QuestionsThere is no dial tone when I lift the telephone handset Telephone Service TroubleshootingDisclaimer TrademarksDocumentation Copyright Notice Software Use NoticeUnited States FCC Compliance FCC ComplianceFCC Declaration of Conformity FCC Part Canada EMI RegulationIC Industry Canada Notice If You Need Technical Assistance For Information