Scientific Atlanta DPX2203, EPX2203 manual Internet Service Install USB Drivers

Internet Service: Install USB Drivers

Introduction

This section contains instructions for installing the WebSTAR cable modem USB drivers if your PC is equipped with a USB interface and a Microsoft Windows 98, 98SE, ME, 2000, or XP operating system. The USB driver installation procedures are different for each operating system. Follow the appropriate instructions in this section for your operating system.

Note: If your PC does not have a USB interface, you may skip this section.

Microsoft Windows 98, 98SE, or ME

Follow these steps to install the WebSTAR cable modem USB drivers for Microsoft Windows 98, 98SE, ME environments.

1.Insert the USB Cable Modem Driver Installation Disk into the CD-ROM drive of your PC.

2.Wait until the POWER and CABLE lights on the cable modem appear solid green; then, plug the USB cable into the USB port on your PC.

Result: The Add New Hardware Wizard window opens.

3.Click Next.

4.In the Add New Hardware Wizard window, select Search for the best driver for your device (Recommended), then click Next.

5.In the Add New Hardware Wizard window, select CD-ROM drive, and then click Next.

6.In the Add New Hardware Wizard window, select The updated driver (Recommended), and then click Next.

7.In the Add New Hardware Wizard window, click Next.

Results:

•The Copying Files window opens.

•After 10 to 20 seconds have passed, the Add New Hardware Wizard window reopens.

8.Click Finish.

Result: The System Settings Change window opens. The driver installation is complete.

9.Click Yes to restart your computer.

Results:

•The computer restarts.

•The USB drivers are now installed on your PC and your cable modem is ready for use.

Note: If you cannot access the Internet, contact your cable service provider for further assistance.

Continued on next page

4004041 Rev A WebSTAR DPX2203 or EPX2203 VoIP Cable Modem User’s Guide 23