Sierra Wireless 300 manual Q0, S86=3

DART 300 Migration Guide		Sample Configurations
Table 2-3 Remote TCP Setup (Server) (continued)
DART 200 Command	DART 300 Equivalent	Description
V0	V0	Use numeric result codes.
Q0 (default)	Q0 (default)	Disable Quiet mode.
F1 (default)	+WS62=0	Data state echo off.
X1 (default)	N/A	Extended result codes. The DART 300 will
		accept the X1 command but takes no action.
&C1 (default)	N/A	DCD follows state of connection. The DART 300
		uses this configuration and does not allow changes
		to DCD function.
&D0 (default)	&D0	Ignore DTR for data state escape.
&E2	S2=43 (Sets TDES escape	Enable the escape sequence and filter it from the
	character to “+”) (default)	packet. The DART 300 ensures TDES is enabled;
		the DART 300 always filters it from the packet.
&S0 (default)	N/A	DSR always active. The DART 300 always
		asserts DSR.
\F3 (default)	Not needed, the next command	Includes PAD forwarding character in packet.
	would change the setting.
\M0 (default)	+WS63=0	Disables PAD forwarding character.
\Q0	Not supported.	No flow control. (See Section 3.1.1 below if
	The DART 300 supports only	hardware flow control is not provided by your
	hardware flow control.	local host device.)
\T1 (default)	+WS70=20	Timed data forwarding (always used with binary
		data). The DART 200 configuration assumes use
		of the default value in S50 (20 tenths of a second).
*B0 (default)	N/A	Disable broadcast reception.
*C1 (default)	N/A	Enable SLIP TCP header compression.
*G1 (default)	N/A	Multicast address selection.
*K2	Not supported.	Receive keep-alive; unidirectional.
	The DART 300 supports only
	an idle session timeout (S30).
S86=3	Not supported.	Keep-alive timer set to 3 minutes.
	The DART 300 supports only a	With the DART 200 setting of *K2 above, the
	bi-directional idle session	DART 300 setting of S30=3 is an equivalent with
	timeout (S30=3).
		the exception that any dummy keep-alive packets
		will not be discarded by the DART 300. See
		Section 3.2.3.1 below for details.
*R0 (default)	N/A	Auto-SLIP disabled.
*T0 (default)	N/A	No Telnet keep-alives.

2110291 Rev 1.0 Page 7